electronics will then assume it has been cleaned manually and a new calculation of the time when the next cleaning is required will be started. During the cleaning process in the Clean&Renew™ the yellow light will flash and will go off after approx. 4 hours when cleaning is finished.
Automatic cleaning
Once the shaver is put into the Clean&Renew™, it is cleaned auto- matically (see separate instructions). Manual cleaning is recommended only when the Clean&Renew™ is not available, e. g. when travelling.
Manual cleaning
The
Regular cleaning ensures better shaving performance. Rinsing the shaver head under running water after each shave is an easy and fast way to keep it clean:
•Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
•Next, switch off the shaver, remove the shaver Foil & Cutter cassette (1) and let it dry.
•If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer
(2) and shaver Foil & Cutter cassette (1).
Alternatively, you may clean the shaver using a brush:
•Switch off the shaver. Remove the shaver Foil & Cutter cassette and tap it out on a flat surface.
•Using a brush, clean the inner area of the shaver head. However, do not clean the shaver Foil & Cutter cassette with a brush as this may damage it.
Replacement light for shaving parts/Reset To maintain 100% shaving performance, replace the shaver Foil & Cutter cassette (1), when the replacement light for shaving parts
(8)comes on (after about 18 months) or when worn.
The replacement light will remind you during the next 7 shaves to replace the foil and cutter cassette. Then the shaver will auto- matically reset.
After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset the counter.
While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Then recharge the shaver to full capacity.
Environmental notice
This appliance contains rechargeable batteries. To protect the environment, do not dispose of the appliance in the
household waste at the end of its useful life. Disposal can take place at a Braun Service Center or appropriate collection sites.
C Clean&Renew™
Braun Clean&Renew™ has been developed for cleaning, charging and storing your shaver. Clean your shaver daily in the Clean&Renew™. During the automated cleaning process, the shaver is switched on and off at intervals
to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfils the lubrication needs of the shaver.
9