Braun service manual 1500

Maintenance and Lubrication Schedule

	Remove pump module cover and inspect:		Resecure, replace or correct as needed.
1500	•	Hydraulic hoses, fittings and connections for wear
	•	or leaks
Cycles		Harness cables, wires, terminals and connections
	•	for securement or damage
		Control board, circuit breaker, power switch and
		lights for securement or damage

Perform all procedures listed in previous section also

4500

Cycles

Inspect cotter pins on platform pivot pin (2)

Hydraulic Fluid (Pump) - Check level. Note: Fluid should be changed if there is visible contamination. Inspect the hydraulic system (cylinder, hoses, fit- tings, seals, etc.) for leaks if fluid level is low.

Inspect cylinders, fittings and hydraulic connections for wear, damage or leaks

Inspect outer barrier cylinder hose assembly (hose, fasteners, connections, etc.) for wear, damage or leakage

Inspect parallel arms, bushings and pivot pins for visible wear or damage

Inspect parallel arm pivot pin mounting bolts (8)

Inspect platform pivot pin, bushings and vertical arms for wear, damage and positive securement

Inspect upper/lower fold arms, rotating pivot slide arms, slide support arms and associated pivot pins, bushings, and bearings for visible wear or damage

Inspect gas springs (cylinders) for wear or damage, proper operation and positive securement (IB)

Inspect rotating pivot slide arm UHMW slide bear- ings (buttons - 2) and UHMW slide (1)

Inspect vertical arm plastic covers Inspect power cable

Mounting

Decals and Antiskid

Resecure, replace or correct as needed

Use Braun 32840-QT (Exxon® Univis HVI 26) hydraulic fluid (do not mix with Dextron III or other hydraulic fluids). Check fluid level with platform lowered fully and roll stop unfolded fully. Fill to within 1/2” of the bottom of the 1-1/2” fill tube (neck).

Tighten, repair or replace if needed.

Tighten, repair or replace if needed.

Replace if needed.

Tighten or replace if needed.

Replace defective parts and resecure as needed. Apply Light Grease during reassembly procedures.

Replace if needed.

Tighten, replace or correct as needed

Apply Door-Ease or replace if needed. See Lubri- cation Diagram.

Resecure or replace if needed. Resecure, repair or replace if needed.

Check to see that the lift is securely anchored to the vehicle and there are no loose bolts, broken welds, or stress fractures.

Replace decals if worn, missing or illegible. Re- place antiskid if worn or missing.

Consecutive

750Cycle Intervals

Repeat all previously listed inspection, lubrica- tion and maintenance procedures at 750 cycle intervals.

Page 15