24ENGLISH
◗Do not lift the razor lever or press the ON/OFF button while the cleaning cycle is running. If this does occur, the cleaning cycle will stop and the razor holder will automatically move to the starting position.The cleaning cycle can be
◗If the power plug is disconnected before the cleaning cycle is complete,the razor holder will remain in its current position. Reconnect the plug into the outlet or Jet Clean System and the razor holder will automatically move to the highest position. The cleaning cycle can be
NOTE: If the cleaning solution level drops below | |
the minimum level during the cleaning cycle, the | |
cleaning light will blink at intervals and razor | |
holder returns the razor to the starting position, | |
stopping the cleaning cycle. Unplug Jet Clean | |
System from the outlet, remove razor and refill | |
canister (see “Preparing Jet Clean system for Use”). | |
C 6 | When the entire cleaning cycle is complete |
| and the razor is hygienically clean, the razor |
| will be raised to the starting position and |
| the charge light on the Jet Clean System will |
| blink indicating that the razor is |
| (re)charging. |
C 7 | Raise the lever holding the razor to the |
| highest position (1) and carefully remove |
| the razor from the Jet Clean System (2). |
ENGLISH 25
◗You may quickly rinse the razor heads with warm water after using the Jet Clean System to remove any residual cleaning solution.
◗If the razor needs to be recharged, you can simply leave it in the Jet Clean System after cleaning and the razor will automatically recharge.The charge light on the Jet Clean System will blink to indicate the razor is recharging.
◗For optimal razor drying time after cleaning, remove razor from Jet Clean System after the cleaning cycle is complete and allow to air dry.
◗You may store your razor in the Jet Clean System. Unplug from the outlet when charging/cleaning is complete.
Quick Cleaning: Razor Heads
The razor heads may also be quickly cleaned after each use by rinsing with hot water. Water from the tap should be on a hot setting, BUT BE CAREFUL TO TEST WATER FIRST SO AS NOT TO BURN OR SCALD HANDS.
◗ Regular cleaning guarantees better shaving results.
◗ Do not immerse razor in water.
C ◗ The tap symbol on the back of the razor indicates that the razor can be rinsed under running tap water.
C ◗ While rinsing razor heads, water may drip out of the base of razor.This is a normal occurrence.