22ENGLISH
◗When the cleaning solution level drops below the minimum level, the cleaning light will blink with intervals and the razor holder will move to the starting position.
◗If you clean your razor every day, you should refill the canister approximately every 15 days.
C 5 | Carefully lower the appliance back onto |
| the Jet Clean canister making sure the |
| release buttons snap back into place. |
Jet Cleaning the Razor
◗If the razor does not contain enough power for one (1) shave, the Jet Clean Cleaning System may not work properly. Charge the razor in the Jet Clean System before using it to clean your razor.
◗The cleaning cycle takes approximately 1 hour to complete.
C 1 | Connect the small plug to the Jet Clean |
| System. Connect the charging plug into |
| any 100V to 240V AC outlet. Use only the |
| charging plug provided. |
The razor holder automatically moves up to the | |
highest position. | |
2. | Place the Jet Clean System on a flat, level |
| surface. Fill the cleaning canister with |
| cleaning solution (see ‘Preparing Jet Clean |
| System For Use’). |
ENGLISH 23
C 3 Remove protective razor head cap from 
razor.
C 4 | Place the razor head side down in the |
| razor holder so that the razor head fits |
| into the configuration shown inside the Jet |
| Clean System. Gently press the base of the |
| razor towards the back of the Jet Clean |
| System so that the razor base fits snugly in |
| place. Lock the razor into place by pushing |
| the lever down completely. |
The charging light will blink to indicate the razor | |
automatically begins to charge. | |
C 5 | Press the ON/OFF button to start the |
| cleaning cycle. |
The cleaning light on the Jet Clean System starts | |
blinking and the razor is automatically lowered | |
into the cleaning solution.The razor stops | |
charging while it is cleaning. | |
◗During the first phase of the cleaning
cycle, the razor will automatically turn on and off several times while the razor holder lowers and raises the razor’s position in the cleaning solution, removing all debris. The cleaning light will blink continuously.
◗During the second phase of the cleaning cycle, the razor holder moves the razor to the drying position and the cleaning light will light up continuously.