Philips 8170XLCC manual Save These Instructions

Page 3

4ENGLISH

IMPORTANT SAFETY

INSTRUCTIONS

When using an electric appliance, basic precautions should always be followed, including the following:

Read all instructions before using this appliance.

DANGER

To reduce the risk of electric shock:

1.Do not reach for a corded razor/Jet Clean System that has fallen into water. Unplug immediately.

2.Use razor only in dry condition. Do not use a razor/Jet Clean System while bathing or in a shower.

3.Do not submerge razor in water.

4.Do not place or store a razor or Jet Clean System where it can fall or be pulled into a tub or sink. Do not place or drop a razor or Jet Clean System into water or other liquid.

5.Always unplug this razor/Jet Clean System from the electrical outlet immediately after use, except when razor is (re)charging.

6.Unplug and remove power supply cord from razor before cleaning.

WARNING

To reduce the risk of burns, fire, electric shock, or injury to persons:

1.Close supervision is necessary when this razor/Jet Clean System is used by, on, or near children or invalids.

2.Use this razor/Jet Clean System for its intended household use as described in this manual. Do not use attachments or a cleaning solution not recommended by Philips Electronics North America Corporation.

3.Never operate this razor/Jet Clean System if it has a damaged cord or charging plug, if it is not working properly, if it has been dropped or damaged, or dropped into water while plugged in. Return the razor/Jet Clean System to the Philips Norelco Service Location for examination and repair.

ENGLISH 5

4.Keep the razor, Jet Clean System, cord and charging plug away from heated surfaces.

5.Never drop or insert any object into any opening.

6.Do not clean, charge or plug in razor/Jet Clean System outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.

7.Do not use this razor with a damaged or broken comb, as facial injury may occur.

8.Always attach plug to razor/Jet Clean System first, then to outlet. Be certain that plug is inserted firmly into razor/Jet Clean System, up to mark indicated on plug. For Jet Clean System use, always put razor in first, attach cord to Jet Clean System, then plug into outlet.To disconnect, turn razor/Jet Clean System off then remove charging plug from outlet.

9.Never put the razor/Jet Clean System in direct sunlight or store at a temperature above 140°F.

10.Razor can be rinsed under running tap water. Do not charge or operate razor corded until fully dried.

11.Keep the Jet Clean System and cord dry at all times. Do not handle with wet hands. Do not store in a damp environment.

12.To prevent possible damage to the cord, do not wrap cord around the razor or Jet Clean System.

SAVE THESE

INSTRUCTIONS

IMPORTANT: The power plug contains a transformer. Do not cut off the power plug to replace it with another plug, as this will cause a hazardous condition.

CAUTION: Keep cleaning solution out of reach of children. Do not take internally. Avoid contact with eyes. In case of eye contact, thoroughly flush with cold water. If irritation persists, get medical attention.

Image 3
Contents With Jet Clean System 8170XLCC Save These Instructions Table of Contents Indicator Light FeaturesON/OFF Jet Clean System Razor LeverLED Battery Level Indicators Before First UseCharging Charging Razor with a Cord Charging Razor with Jet Clean SystemPut It To The Test & Shaving Tips Razor from the Jet Clean SystemRecharging Quick ChargeTrimming CleaningLocated inside the canister Preparing Jet Clean System For UsePlace the Jet Clean System on a flat,level surface Canister up to the MAX indicationJet Cleaning the Razor Quick Cleaning Razor Heads Blink indicating that the razor isRecharging After Each Use Trimmer Cleaning the Jet Clean CanisterMaintenance Replacing the Razor HeadsRazor head check indication Assistance AccessoriesReplacement Heads StorageFull TWO Year Warranty