Control guide
Main unit
Standby indicator [^]
When the unit is connected to the AC mains supply, this indicator lights up in standby mode and goes out when the unit is turned on.
Standby/on switch [POWER 8]
Press to switch the unit from on to standby mode or vice versa.
In standby mode, the unit is still consuming a small amount of power.
[SPEAKERS]
For selecting speakers on or off.
Turning the speakers off automatically engages the STEREO/2CH MIX mode (when listening through headphones, for example).
[-HELP, –RESET]
Press if an error message appears. A message offering a possible solution scrolls across the display.
To reinitiate the unit’s settings, press and hold until “RESET” appears.
[% DIGITAL, % PLⅡ , DTS]
Lights to indicate the source’s input signal and decoding format used.
%DIGITAL: Dolby Digital sources
%PL Ⅱ : Dolby Pro Logic Ⅱ decoder is being used
DTS: DTS sources
[INPUT SELECTOR]
For selecting input.
[VOLUME]
Volume control.
Remote control signal sensor
| INPUT SELECTOR | VOLUME |
|
|
|
| |
SPEAKERS |
|
| |
POWER 8 |
|
|
|
|
| DOWN | UP |
|
|
| PHONES |
[BAND]
For switching between FM and AM.
[FM MODE]
If reception is poor in FM, switch to the monaural mode by pressing until “MONO” appears.
[MEMORY]
For presetting radio stations.
[TUNE 2, 1]
For tuning the radio and selecting preset stations.
Press and hold until the frequency starts scrolling to start automatic tuning. Tuning stops when a station is found.
[PHONES]
Headphone jack
Plug type: 6.3 mm (1/4'') stereo
• Avoid listening for prolonged periods of time to prevent hearing damage.
•Turn the speakers off
when using the headphones.
Display
• When you turn the dimmer to “ON”, the following indicators change to dim.
Operations
[ SPEAKERS]
Speaker indicator
Lights when the speakers are on.
[TUNED, ST, , MONO]
Radio indicators
TUNED: A station is tuned.
ST: A stereo FM broadcast is tuned.
: Flashes or lights during presetting. MONO: Lights when using the monaural
mode.
[SLEEP]
Sleep timer indicator.
[SFC, 2CH MIX]
SFC: Lights when using an SFC mode.
2CH MIX: Lights when playing
a
[–DIGITAL INPUT–, L, C, R, S,
LS, RS, LFE]
Program format indicators
Show the channels contained in the digital input signal. They do not light when input is analog.
L:Front left channel
C:Center channel
R:Front right channel
S:If the surround channel is monaural.
LS: Surround left channel
RS: Surround right channel
LFE (Low Frequency Effects):
RQT7512
12 |
General display
Shows the input mode, radio frequency, and other general information.
SPEAKERS | TUNED ST M | SFC | DIGITAL INPUT | |||
| MONO SLEEP | 2CH MIX | L | C | R | S |
|
|
| LS |
| RS LFE | |
|
|
| DIGITAL |
|
| |
|
|
| PROCESSING fs | |||
|
| kHz |
|
|
|
|
|
| MHz |
|
|
| kHz |
[DIGITAL PROCESSING fs]
Displays the frequency the unit is processing.
[kHz, MHz]
Frequency unit indicators
kHz: AM, or PCM sampling frequency
MHz: FM