USE OF YOUR PRODUCT (continued)
3. Starting the measurement
•Press and release the O/I button.
•Ensure that the “ready to measure” sign “
” is displayed and a beep sound is heard before measurement. If the START button is pressed before the sign is displayed, the thermometer will not start the measurement.
•It will beep once and measurement will begin.
•After one second, the ear thermometer will give out a beeping sound to signal completion of measurement. Remove the ear thermometer from the ear canal and check the reading on the display panel.
•If you want to repeat the measurement, start measuring after it
beeps (about 10 seconds after the last measurement) and the “ready to measure” sign “
” is displayed. You can repeat the process again from step 3 onwards.
4. Power off
•Power will be automatically turned if the thermometer is left unattended for 1 minute.
TROUBLESHOOTING
If you encounter problems with the operation of your Ear Thermometer, please check the following points to see if they can be rectified. If the problem still persists, please contact the service center for servicing.
Do not disassemble or attempt to repair the thermometer yourself.
Conditions | Possible cause and solution |
|
|
• Nothing is displayed after O/I | • Battery may be worn out. |
button pressed | • Replace with new battery. |
| • Battery may not be placed in |
| the correct polarities. |
| • Place batteries according to |
| the polarities indicated |
|
|
9