Operating Instructions, Battery Charging Procedure

CHAPTER 2

OPERATING INSTRUCTIONS

2.1BATTERY CHARGING PROCEDURE

Your AGRI-THERM II has been charged at the factory before shipment. However, you may want to charge it again overnight before extended use. To recharge the batteries in your AGRI-THERM II Infrared Thermometer, plug the plug on the end of the six-foot lead of the supplied battery charger into the Rear Panel

Jack of the infrared thermometer labeled “BATT.” The “BATT” jack can be found on the left hand side of the Rear Panel. Then, plug the AC adaptor into 90-250 Volt AC 50/60 Hz power source.

Allow ten (10) hours for a complete charge; partial charges are okay. When charging is complete, unplug the AC adaptor from the outlet and then remove the plug from the instrument.

2.2 ABBREVIATIONS ON REAR PANEL

The abbreviations on the Rear Panel of the AGRI-THERM II stand for the following:

9SEL = Select: IR, DIFF or AMB

9IR = Infrared Surface Temperature Reading

This is the current infrared surface temperature reading of the target that the instrument is focused on.

9DIFF = Temperature Differential

This is the Difference between the Dry Bulb Ambient Air Temperature and the Temperature of the target.

9AMB = Dry Bulb Ambient Air Temperature

This is the temperature of the ambient air surrounding the Infrared Thermometer.

9PWR = Power: On/Off

9LITE = TTL Intra-Optical Light Sighting: On/Off

9DATA = Plug for outputting the data selected by “SEL” at the rate of 10mV/º.

9BATT = Place to plug in battery charger.