Invacare 1600, 1300, 1500, 1200 manual Installing the Short Stretcher Padded Cover, Seat Straps

ACCESSORIES

Installing the Short Stretcher Padded Cover

NOTE: For this procedure, refer to 3. on page 29, FIGURE 6.2, FIGURE 6.3 on page 31, FIGURE 6.4 on page 31 and FIGURE 6.5 on page 32.

NOTE: This procedure applies to the Padded Mesh Stretcher Cover.

1.Press and hold the buttons on the stretcher frame (Detail “A” of FIGURE 6.1).

2.Raise the right and left ends of the stretcher to an upright position.

3.Position the three seat straps horizontally across the seat frame (FIGURE 6.2). NOTE: The seat straps are labeled with an “S” on the buckle.

4.Attach the three seat straps to the seat frame.

5.Ensure the buckles are on the bottom of the seat.

6.Tighten the seat straps until they are snug. DO NOT overtighten the straps, otherwise the wing arms will not lower smoothly to the flat position.

Wing Arm

Seat Strap

Wing Arm

Seat Frame Buckle

FIGURE 6.2 Seat Straps

7.If necessary, raise the right or left wing arm of the stretcher to prepare the head end (FIGURE 6.3).

8.Position the two back straps vertically onto the head end of the stretcher.

NOTE: The back straps are labeled with a “B” on the buckle.

9.Attach the two back straps to the head end of the stretcher.

10.Ensure the buckles are on the outside of the stretcher.

11.Ensure the two back straps are tight.

Traverse Lift/Transporter 30 Part No. 1150696