After Use, Adjusting the Width, Disassembly

5.Tighten the two screws H in the end stop I.

3.5 Adjusting the Width

Follow this procedure to adjust the freestanding rail system to the room size.

1.Loosen the two yellow thumb screws F on the top the bracket C.

2.Push or pull the top bracket C to adjust the width of the system.

3.Tighten the thumb screws F to secure the top bracket C to the rail E.

4.Repeat STEPS 1–3 for the other side of the freestanding rail system.

Follow this procedure to adjust the height of the rail.

1.Locate the height adjustment socket M at the side of the vertical pole B.

2.Insert the provided 5 mm Allen key N in the height adjustment socket at the side of the vertical pole.

3.Turn the Allen key to adjust the height of the freestanding rail system.

4.Repeat STEPS 1–3 for the opposite vertical pole.

5.Make sure the top bracket and rail are level.

Use a spirit level to ensure the top bracket and rail are level.

1.Use the enclosed hook and loop fastening strips (not shown) to secure the recharging dock A to the lower portion of the vertical pole B.

1.Lower the vertical poles to the lowest position. 3.6 Adjusting the Height, page 5 .

2.Performing one of the following:

•Reverse the hoist installation steps to remove the hoist. Refer to 3.4 Installing the Hoist, page 4 .

•Loosen the screws H in the end stops I and move the end stops on either side of the hoist to secure the hoist in position.

1183379A