Lifescan blood glucose monitoring system manual Apply Blood Sample

Page 43

M C

Obtain a drop of blood from your fin- ger using the PENLET® II Automatic Blood Sampler. (See Getting a Drop of Blood, pages 28–32.)

Step 2: Apply Blood Sample.

With the test strip in the meter and

TESTING

appears for a moment. Then

on the display, apply a drop of blood to the test spot.

appears for five minutes or until you apply blood to the test spot.

36

Image 43 Lifescan blood glucose monitoring system manual Apply Blood Sample
Contents Manuel du propriétaire Page Important phone numbers Table of Contents Introduction Immediately After Testing Using the Meter Memory Solving Problems Introduction Why Blood Glucose Testing Is ImportantIntroduction Precautions and Limitations Precautions Complete ONE Touch Profile System Getting StartedD e ONE Touch Profile Blood Glucose Meter Battery Compartment. Holds two ONE Touch Test Strips Important Test Strip Information ONE Touch Control Solution Coding the ONE Touch Profile Meter Before TestingMatch the Code Numbers Press the On/Off ButtonChecking the System Code the MeterChecking with the Check Strip Press the On/Off Button. Insert Side 1 of the Check Strip How to do a Check Strip TestExample Before Testing Checking with Control Solution Do a control solution test Important Control Solution Test Information Press On/Off Button. Insert Test Strip How to do a control solution testControl Solution Result Appears in 45 Seconds Apply Control SolutionSome parts of Europe Control solution resultsBefore Testing Abbreviated Test Procedure Testing Your BloodTest Strips Getting a Drop of Blood Insert a Lancet Penlet II Automatic Blood SamplerTesting Cock the Penlet II Sampler Get a Drop of Blood Testing Remove the Lancet How to Test Your Blood With the meter display showing Apply Blood Sample Are applying blood. If the test Step Accurate Results 45 SecondsSpecial Messages Testing Checking the Amount of Blood on the Test Strip Low result. Repeat the test with a Event Labeling Immediately After TestingExample List includes Insulin ProgrammingChanging the Insulin Units Carbohydrate Counting After Testing Recent Diabetes Findings Frequency of TestingWhat This Means for You Comparing Meter and Laboratory Results Expected Test Results Target Range Testing Tips to Ensure Accuracy Before testing Results Health Conditions Causing Out-of-Range Results Recommendations for Better Diabetes Control Results Entering the Memory Mode Using the Meter MemoryFirst time and have not used it for Event Averages Recalling Test Results Changing an Insulin Record Event LabelsDeleting an Insulin Record Entering and Using the Options Mode Setting Meter OptionsOptions Beep Prompts Setting the Time Setting the Date Event Averaging Insulin Programming Options Display Language Unit of Measure Date FormatDecimal Separator Exiting the Options ModeTest Procedure Messages Solving ProblemsApply √ok Hi mmol/l Message Problem What to do Error MessagesThere is dirt, blood, or Clean the test area Test strip moved Blood or control Repeat the test with a Check strip test result Clean the meter and check Reset Taking Care of Your Meter Remove the Test Strip Holder from the Meter Cleaning the MeterDoing a Daily Check Remove the test strip holder to expose Clean the Test Strip HolderTest area Do not use Clean the Test AreaReplace the Test Strip Holder Replacing the Batteries To replace the batteries Meter Care Specifications Complies with Canadian ICES-001 Day Money-Back Guarantee Guarantee and WarrantyWarranty LifeScan Customer Care Line/Ligne InfoSoins 800 Canada
Related manuals
Manual 77 pages 38.04 Kb Manual 85 pages 3.35 Kb