Lifescan blood glucose monitoring system manual How to do a Check Strip Test

Page 23

BEFORE TESTING

How to do a Check Strip Test:

Step 1: Press the On/Off Button. Insert Side 1 of the Check Strip.

The code number will appear on the display. When insert code 10 (Example) strip appears, slide the notched end of the check strip into the test strip

holder with Side 1 (purple

M C

side) facing up.

wait please appears for a

moment.1

Step 2: When apply sample

Appears, Remove the Check Strip from the Test Strip Holder.

Note: This is the only time you should remove a test strip during a test.

M C

1

16

Image 23

Contents Manuel du propriétaire Page Important phone numbers Table of Contents Introduction Immediately After Testing Using the Meter Memory Solving Problems Introduction Why Blood Glucose Testing Is ImportantIntroduction Precautions and Limitations Precautions Complete ONE Touch Profile System Getting StartedD e ONE Touch Profile Blood Glucose Meter Battery Compartment. Holds two ONE Touch Test Strips Important Test Strip Information ONE Touch Control Solution Coding the ONE Touch Profile Meter Before TestingMatch the Code Numbers Press the On/Off ButtonChecking the System Code the MeterChecking with the Check Strip Press the On/Off Button. Insert Side 1 of the Check Strip How to do a Check Strip TestExample Before Testing Checking with Control Solution Do a control solution test Important Control Solution Test Information Press On/Off Button. Insert Test Strip How to do a control solution testControl Solution Result Appears in 45 Seconds Apply Control SolutionSome parts of Europe Control solution resultsBefore Testing Abbreviated Test Procedure Testing Your BloodTest Strips Getting a Drop of Blood Insert a Lancet Penlet II Automatic Blood SamplerTesting Cock the Penlet II Sampler Get a Drop of Blood Testing Remove the Lancet How to Test Your Blood With the meter display showing Apply Blood Sample Are applying blood. If the test Step Accurate Results 45 SecondsSpecial Messages Testing Checking the Amount of Blood on the Test Strip Low result. Repeat the test with a Event Labeling Immediately After TestingExample List includes Insulin ProgrammingChanging the Insulin Units Carbohydrate Counting After Testing What This Means for You Frequency of TestingRecent Diabetes Findings Comparing Meter and Laboratory Results Expected Test Results Target Range Testing Tips to Ensure Accuracy Before testing Results Health Conditions Causing Out-of-Range Results Recommendations for Better Diabetes Control Results Entering the Memory Mode Using the Meter MemoryFirst time and have not used it for Event Averages Recalling Test Results Changing an Insulin Record Event LabelsDeleting an Insulin Record Entering and Using the Options Mode Setting Meter OptionsOptions Beep Prompts Setting the Time Setting the Date Event Averaging Insulin Programming Options Display Language Unit of Measure Date FormatDecimal Separator Exiting the Options ModeTest Procedure Messages Solving ProblemsApply √ok Hi mmol/l Message Problem What to do Error MessagesThere is dirt, blood, or Clean the test area Test strip moved Blood or control Repeat the test with a Check strip test result Clean the meter and check Reset Taking Care of Your Meter Doing a Daily Check Cleaning the MeterRemove the Test Strip Holder from the Meter Test area Clean the Test Strip HolderRemove the test strip holder to expose Do not use Clean the Test AreaReplace the Test Strip Holder Replacing the Batteries To replace the batteries Meter Care Specifications Complies with Canadian ICES-001 Day Money-Back Guarantee Guarantee and WarrantyWarranty LifeScan Customer Care Line/Ligne InfoSoins 800 Canada

Related manuals

Manual 77 pages 38.04 Kb

Manual 85 pages 3.35 Kb