Intel 05-2372-001 manual System Release 6.0 cPCI Feature Pack 1 for Windows September

–IPT4800C: 480 Channel IP Gateway w/ LBR coders, RFC2833, T.38, and Gigabit on-board data network interfaces. Up to 20% (96) of the IP channels may be used for T.38 relay.

–IPT2400C: 240 Channel IP Gateway w/ LBR coders, RFC2833, T.38, and Gigabit on-board data network interfaces. Up to 20% (48) of the IP channels may be used for T.38 relay.

–IPT1200C: 120 Channel IP Gateway w/ LBR coders, RFC2833, T.38, and Gigabit on-board data network interfaces.

•New SS7 products

–SIU520

–SIU131

–SIU231

–CPM8

•Redundant System Swap (RSS) / Redundant Host (RH)

–Windows 2000 SP4 only

–Supported on the following platforms:

•Intel® NetStructure™ ZT5085 with ZT5524A-1A SBC (Dual CPU)

•Intel® NetStructure™ ZT5085 with ZT5524A-1B SBC (Single CPU)

•Peripheral Hot Swap (PHS) on the following chassis:

–Supported on Microsoft Windows 2000 only

–Supported on the following platforms:

•Intel® NetStructure™ ZT5085

•Westek P5100 with Advantech MIC-3358 SBC

•Advantech MIC-3038 with MIC-3358 SBC

Note: PHS is only supported on the Microsoft Windows 2000 operating system.

•OA&M enhancements

–Activate and de-activate Layer 2 (D-Channel). The Global Call API can now be used to set the logical data link (D-channel) state using the gc_Extension( ) function with extension ID (ext_id) of GDIS_EXID_SETDLINKSTATE. For more information, see the Global Call ISDN Technology Guide

–Re-configure trunks between ISDN and Clear Channel (on DMT160TEC and DMN160TEC boards). See the section, “Configuring Trunks for Clear Channel Signaling”, in the Intel NetStructure for DM3 Architecture for cPCI on Windows for more information.

–Ability to dynamically configure the following trunk parameters at runtime:

•CRC4 ON or CRC4 OFF

•Selecting between user and network modes

•Support for Global Call Alarm Management System (GCAMS)

•Overlap Send/Receive support for CAS

•Support T.38 relay mode (gateway) on Intel® NetStructure™ DM/IP and IPT Series boards

•Support QoS alarm monitoring on DM/IP and IPT Series boards

•Interoperable with CISCO 5300 running IOS 12.3(1)

System Release 6.0 cPCI Feature Pack 1 for Windows — September 2004 7