CLEANING — BLADE ADJUSTMENTS
Always disconnect the spark plug wire before cleaning the inside of the drum.
Never pour or spray water over the gasoline engine or electric motor.
For consistent performance, long life and high quality mixing, thoroughly clean the mixer inside and out at the end of each day’s operation.To prevent lumps of dried mortar from forming and contamination of future batches, do not allow a buildup of materials to form on the blades or anywhere inside the drum.
The following is the recommended wiper blade adjustments:
1) STEEL DRUM MIXERS
SIDE SCRAPER
EM-700S & 700P — OPERATIONS
ENDSCRAPER
2) POLYETHYLENE DRUM MIXERS
The poly blade should come as close as possible to the surface without touching. If material builds up on the drum, you may use a rubber mallet to dislodge the material without adverse effect to the drum.
IMPORTANT NOTICE
EPOXY COMPATIBILITY — There are some expoxies and other chemicals used in certain applications that are not compatible with polyethylene tubs.
Since Whiteman Industries cannot control the end user’s application of this product, we will not assume responsibility for the resulting damages when exposed to incompatible chemicals.
ESSICK