Assembly (continued)
Connect The Throttle Cable
1.Loop the ribbed cable tube to the top left side of the engine.
2.Install the black wire between the two cable adjuster nuts as shown.
3.Connect the
Ignition |
Leads |
Cable |
Adjuster |
23146 |
Adjusting the Throttle Cable
1.Insert the throttle cable housing into the notch on the fan cover, and clamp the black wire’s connector between the fan cover and the cable outer adjuster nut. See Figure 10.
IMPORTANT!
Adjust and tighten the cable nuts to allow approximately
2.Tighten the two throttle cable adjuster nuts.
3.Using finger pressure only, connect the black switch wire from the cable tube to the red ignition wire on the powerhead. Wire routing must be as shown in the illustration with the black wire located over the spark plug wire..
4.Reinstall the cylinder cover and tighten the three cover screws.
5.Reinstall the spark plug boot.
CAUTION!
Routing of wiring must not interfere with throttle operation.
Assembling tube sections
1.Place powerhead/lower tube assem- bly on a clean, flat surface so that both assemblies fit end to end. The powerhead/lower tube assembly should be facing positioned with the locking hole in the tube end facing up.
CAUTION!
Keep the open ends of the tubes clean and free of debris!
Black wire | Spark plug |
boot |
Red wire
Ignition ground
lead (Black wire)
Latch protector (extended)
Lower tube assembly
Latch
Locking hole
Coupler screw
Knob
Coupler | Tool assembly |
|