Installation and repair should be done by a qualified service person. The heater should be inspected before use and at least annually by a qualified service person. More frequent cleanings may be required as necessary. It is imperative that control compartments, burners, and circulating air passageways of the heater be kept clean.
CAUTION: The gas pressure regulator provided with this ap- pliance must be used. This regu- lator is set for an output pressure of 11" W.C. (2.74 kPa).
PROPANE/LP SAFETY
WARNING: For outdoor use only.
ASPHYXIATION HAZARD
•Do not use this heater for heating human living quarters.
•Do not use in unventilated areas.
•The flow of combustion and ventilation air must not be obstructed.
•Proper ventilation air must be provided to support the combustion air require- ments of the heater being used.
•Refer to the specification section of the heater’s manual, heater data plate, or contact DESA Heating Products to determine combustion air ventilation requirements of the heater.
•Lack of proper ventilation air will lead to improper combustion.
•Improper combustion can lead to carbon monoxide poisoning leading to serious injury or death. Symptom of carbon mon- oxide poisoning can include headaches dizziness and difficulty in breathing.
ASSEMBLY
INSTRUCTIONS
Tools Required: |
|
#2 Philips Head Screwdriver | 1 |
Adjustable Wrench | 2 |
Inspect heater components for possible shipping damage. If any is found, immediately notify the dealer. Check to make sure that all components are included with your heater (see pages 10 and 11).
POLE ASSEMBLY
1.Attach legs to base using large bolts (2), lock washers (2), and large nuts (2 per leg). See Figure 1. Insert bolts from through legs and into top of base. Attach lock washers and nuts from underneath base. Finger tighten only. Do not fully tighten until next step.
2.Secure pole support to legs using 6 large bolts, lock washers and large nuts per leg. Wrench tighten the nuts and bolts from step 1 (see Figure 1).
3.Attach ballast weight to base using one, long bolt, large lock washer and large nut (see Figure 1).
Pole
Support
Legs 
Base
Ballast 
Weight
Figure 1 - Base Assembly
4 | www.desatech.com |
