APC ACF202BLK quick start Lock the unit to the enclosure, Blanking panels

Page 14

Installation

2.Slide the fan assembly towards the rear of the enclosure. Press in the locking tabs on each side of the unit, and slide the unit back as far as it will go.

Lock the unit to the enclosure

1.Use four M6 × 16mm Phillips head screws and four plastic washers to lock the fan assembly to the enclosure.

Blanking panels

Blanking panels are necessary to to prevent hot exhaust air from entering the intake vents of your network and IT equipment. For proper operation, all openings in the enclosure should be covered using standard blanking plates (not provided).

Rack Side Air Distribution Unit

11

Image 14
Contents Rack Side Air Distribution Unit Page Contents Introduction FeaturesGeneral Information Safety information Inventory Receiving and inspectionTools required-not provided InstallationEquipment placement considerations Air-turning vane configurations Assemble the air-turning vane to the mounting rail DownflowInstalling the mounting rails Installation Installation Install the fan assembly into the mounting rails Side viewLock the unit to the enclosure Blanking panelsConnect the power supply Features and controls OperationStart-Up and fan test Warranty limitations Warranty and ServiceLimited warranty Obtaining serviceSpecifications DimensionsAPC Worldwide Customer Support