APC ACF202BLK quick start Air-turning vane configurations

Page 8

Installation

Air-turning vane configurations

The Rack Side Air Distribution Unit is configured at the factory to discharge air out the right side of the unit. Check your product airflow needs and, if necessary, adjust the air-turning vane configuration during the installation procedure.

LeftRight

Up

Down

Change the air discharge to the left side of the unit.

1. Remove the air discharge plate by removing the two screws.

2.Install the discharge plate on the right side of the fan assembly.

3.Install the air-turning vane on the left side of the fan assembly.

See “Assemble the air-turning vane to the mounting rail” on page 6 for instructions on how to install the turning vane.

Rack Side Air Distribution Unit

5

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Rack Side Air Distribution Unit Page Contents Introduction FeaturesGeneral Information Safety information Inventory Receiving and inspectionTools required-not provided InstallationEquipment placement considerations Air-turning vane configurations Assemble the air-turning vane to the mounting rail DownflowInstalling the mounting rails Installation Installation Install the fan assembly into the mounting rails Side viewLock the unit to the enclosure Blanking panelsConnect the power supply Features and controls OperationStart-Up and fan test Warranty and Service Limited warrantyWarranty limitations Obtaining serviceSpecifications DimensionsAPC Worldwide Customer Support
Top Page Image Contents