Plantronics WG201/B manual Checking Battery Status, Automatic Battery Status Alerts

Page 10

Checking Battery Status

To check the battery status, the headset must be powered on. Short press the power button. The indicator light flashes red to show the battery charge level as shown below.

Charge Indicator Lights

Red Flashes

Battery Level

S

More than 2/3 full

S S

1/3 to 2/3 full

S S S

Less than 1/3 full

Automatic Battery Status Alerts

When the battery charge is very low, a tone and voice prompt in English will automatically occur. See below.

Low Battery Warnings

 

 

 

 

Battery Level

Tone

Voice Prompt

 

 

 

30 minutes of talk

Double high tone

“Battery Low”

time remaining

every 15 minutes

repeats every

(this alert only occurs

 

30 minutes

during an active call)

 

 

 

 

 

10 minutes of talk

Triple high tone

“Recharge Battery”

time remaining

every 30 seconds

repeats every 3

 

 

minutes

 

 

 

Out of Range Warning

If you are on a call you will hear the audio degrade as you move out of range.

If you stay out of range, active calls will be suspended. Calls will be re-established upon walking back into range.

Pairing Headset to USB Adapter

The headset and USB adapter are supplied paired to each other. However, if you wish to use a replacement headset with your existing USB adapter, the units can be paired to each other by the following method:

1Ensure your replacement headset is fully charged.

2Press and hold the power button until the indicator light flashes red and blue. The headset is now in pairing mode.

Note If you don’t see the red and blue flash, press and hold the power button to turn your headset off. Then press and hold the power button again until you see the red and blue flash.

3Place the USB adapter in pairing mode by pressing and holding the pairing button on the adapter for two seconds. The pairing light will flash red and blue.

4When the pairing light on the USB adapter goes solid blue, the headset and the USB adapter are paired.

NOTE Take caution pairing the USB adapter. Do not press hard. Please “press” with both fingers rather than push on the USB adapter to avoid damage to the USB adapter or USB port.

Plantronics Voyager PRO UC User Guide

10

Image 10
Contents Voyager PRO UC Wireless Headset System WG201/B Welcome Contents Package Contents and Features Voyager PRO UC USB Adapter Features Charging Headset Set UpConnecting USB Adapter to PC Fitting HeadsetChanging Eartips To place a call To answer a call on the headset Powering Headset On/OffTo end a call on the headset System Information USB Adapter Indicator LightHeadset Controls and Indicators Muting Headset During a CallPairing Headset to USB Adapter Checking Battery StatusAutomatic Battery Status Alerts Out of Range WarningUsing Your Headset with your Bluetooth Mobile Phone Pairing your Headset to your Bluetooth Mobile PhonePerSono Suite Software Battery LifeSoftphone Support Feature Settings Default Settings Screen Headset and USB AdapterHelp for USB Adapter Settings Audio BandwidthPC Panel Screen Advanced SettingsUpdates Support ScreenTroubleshooting Microsoft Office Communicator Usage Troubleshooting and Common QuestionsSound is distorted or I hear an echo in the headset Troubleshooting Mobile Phone Usage Plantronics, Inc Encinal Street Santa Cruz, CA United States