GE 2-9730 manual Case of Difficulty

Page 18

IN CASE OF DIFFICULTY

In case of difficulty, check the following before seeking service.

1 PROBLEM

No Dial Tone

SOLUTION

1.Check Installation:

Is BASE POWER CORD connected to a working outlet?

Is CHARGING LIGHT lit on HA NDSEP

Do not use an outlet that can be turned ON and OFF by a wall switch.

Is TELEPHONE LINE CORD connected firmly to the base unit and phone outlet?

Is BASE ANTENNA raised?

2.Is CORDLESS HANDSET out of range of the base?

3.Make sure BATTERIES are properly charged (12 Hours).

4.Is the BATTERY PACK installed correctly (see page 11)?

5.Did the CORDLESS HANDSET beep when you pressed the phone button? Did the phone light come on? If not, your cordless may need to be charged.

6.Disconnect CORDLESS PHONE and connect another phone to the same jack. If no dial tone, then the problem may be in your wiring or local service.

7.Whenever a Dower outaae occurs, or batieries are reDlaced, the

HANDSET m“ust be retu;ned to the BASE to reset Securiw Code

Dial Tone but can’t dial out

Handset does not ring

8.If you have pulse service on your line, your TONEIPULSE Switch on the Base must be set on Pulse.

9.Make sure RINGER Switch on Handset is “ON”.

10.Do you have too many extension phones on your te!ephone line? Try unplugging some other phones.

11.Perform checks 1,2,3,4,5,6 and 7 above.

You experience

static, noise, or fading

in and out

Unit beeps.

Memory Dialing

Problems

12.ISBASE ANTENNA raised?

13.Is HANDSET out of range from the BASE? Move closer to BASE.

14.Does the BASE need to be relocated?

15.Is CORDLESS BASE plugged into an outlet with household appliances? If so move the appliance or telephone.

16.Check installation per 1 above. (See 7 above)

17.Charge 8ATTERYfor 12 hours.

18.Clean charging contacts on HANDSET and CRADLE with a soft cloth.

19.Check installation per 1 above.

20.Replace BATTERY.

21.Did you program the memory correctly (see page 15)?

22.Did you follow proper dialing sequence (see page 12)?

23.See 8 above.

24.Did you reprogram numbers into memory after power outage or replacing Battery? (See Page 17)

19

Image 18
Contents Page Table of Contents Introduction PatisCheck List Above all, keep within the range of the Base CordlessFeatures CordlessTelephone Controls and Features Cordless Handset Controls Dial Button Used when dialing a number storedContains consumer replaceable Nickel Cadmium Battery Pack Index for numbers stored in the correspondingInstallation Telephone Outlet Requirements Quick Set-upModular wall jack Place Handset in Base to charge battery Raise Antenna on BaseWall Mounting Base Cradle optional Insed antenna and screw into placePower to enable the Handset to be left out More Charge L/GHTwili be on when the batteyMaking When finished, press Phone button to hang upTelephone Operation CallsShort beep in Phone on a long warbling tone with ~ G. FlashCordless HANDS= is capable of receiving the distinctive ChargingStoring ~ B. Changing a Stored NumberTelephone Memory Operation ~ C. PauseChain Dial from MemoW ~. Battery Replacement Product CareAntenna General Product CareCase of Difficulty Service ONE Year Limited WarrantyWhat will we do? For credit card Purchases BT-122346 $9.95Accessory Order Form FCC Registration Information Interference InformationHearing AID Compatibility ~~ m~