Plantronics CS520A, CS510A manual Check configuration and make a test call

Page 10

Check configuration and make a test call

1If your desk phone has a volume control, set it to mid-range.

2Look at the bottom panel of your base and make sure the default settings are correct. Set your desk phone’s volume as well.

listening volume dial ( ) = 2 and speaking volume dial ( ) = 2 configuration switch = A

desk phone volume = mid-range

3Remove the handset from the desk phone cradle.

4While wearing your headset, press the call control button on the headset.

5If you do not hear a dial tone, adjust the configuration switch (A-G) until you do. NOTE For most phones, these factory default settings will sound the best.

6Dial a test call from the desk phone. If needed, fine-tune the volume with the headset volume controls. You can also adjust the desk phone speaking and listening volumes on the bottom of the base.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents CS510A/CS520A Contents Welcome What’s in the box Base and headset basics Base overviewAccessories Adjust the headband Headset set-upConnect your desk phone Connect the powerCharge the headset Connect and configure your desk phone Desk phone standardCheck configuration and make a test call Desk phone plus HL10 lifter sold separately USEIf you do not hear a dial tone Additional parts if requiredDesk phone plus EHS cable Position your base Headset controls Your headsetTalk time Low battery warning BatteryAdjusting your headset volume Muting your headset during a callBase phone button and switches Subscription button Your baseWideband/narrowband audio switch Auto answer switchPlace an outgoing call Conference up to three additional headsetsDaily use Answer an incoming callHeadset TroubleshootingDesk phone Need More HELP?
Top Page Image Contents