Below are the steps to the ‘Caller ID’ setting. The same procedures are used for ‘Prompt’ and
Press and release the Talk Button, say “Setup Menu”, then say “Caller ID”. MV900 will prompt the current mode (ON or OFF). If you say “Yes”, the MV900 will keep the current settings and the voice prompt will repeat “Set Up”.If you say “No”, the MV900 will toggle and prompt next option. When you have heard the one you want, say “Yes” to save.
Setup Option Commands in Setup Menu
Prompt | ON |
| OFF |
Caller ID | ON |
| OFF |
| ON |
| OFF |
|
|
Voice prompt announcement for an easier operation No voice prompt for a faster operation. Recommend for experienced users after becoming familiar with all commands. Says the Caller ID for all incoming calls
Does not say the Caller ID for incoming calls
Enable the power save mode while in Bluetooth (This might create connection lost issue since many Bluetooth phones do not support this mode)
Disable the power saved mode, this will guarantee Bluetooth connection. Factory setting is set to OFF.
Table for numbers stored in MV900’s memory
Number Type | Number |
Home
Work
Voicemail Home
Voicemail Work
Voicemail Cell Phone
Memory 1
Memory 2
Memory 3
Memory 4
Memory 5
Memory 6
Memory 7
Memory 8
Memory 9
Extension
13