Toshiba FT-8001 AW manual Wall mount template

Page 9

•Route the cords through the guides.

•Place the base unit on the posts of the wall plate and push down until it is firmly seated.

•USE ONLY WITH Supplied AC ADAPTOR (TAC-8001 power source AC 120V, 60Hz/DC 9V).

Notes

•Do not use any outlet controlled by a wall switch.

•If you don’t have a standard wall plate, cut out the template on this page and use it to position two screws (minimum length of 13/8 inches) into the wall with the heads protruding about 1/4 inch.

CUT

CUT

Wall mount template

IMPORTANT:

•Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone.

•Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard.

8

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Page Important Safety Instructions Rbrctm Seal Service Requirements Important Instructions to UsersFCC Requirements Introduction FeaturesSetting UP the Base Unit InstallationCharge the Battery Pack Mounting on a Standard Wall Plate Wall MountingWall mount template Locations of Controls Handset ControlsBase Unit Controls Setting the Dial Mode Making a Call Making a CallAnswering a Call Changing the Handset Speaker Volume Changing the Ringer VolumeUsing the Call Waiting SERVICE, ETC Interference or StaticMuting PagingOUT of Range Storing Numbers Memory DialingDialing a Stored Number Inserting a Pause in MemoryChain Dialing Accessories Problem Solution Troubleshooting GuideProblem Solution TELEPHONE/TELEPHONE Answer Machine Limited Warranty WARRANTY/SERVICE
Top Page Image Contents