Linksys SPA962, SPA942, SPA932, SPA922 manual Managing Ring Tones

Customizing SPA9x2 Phones

Ring Tone Parameters

Managing Ring Tones

Ten ring tones appear by default.

You can configure the characteristics of each ring tone using a Ring Tone script. In a Ring Tone script, you can assign a name for the ring tone, and specify:

•Name (n)—Ring tone name, such as Classic, Simple, and Office

•Waveform (w)—1, 2, 3, or 4

•Cadence (c)—1, 2, 3, 4, or 5

You can also download one of two available ring tones (user ring tone 1 or 2) using TFTP:

http://phone_ip_addr/ringtone1?[url]

•Where the URL syntax is tftp://host[:port]/path.

•The default host is the TFTP host.

•Port is optional. The default port is 69.

•The link is case sensitive.

User-downloaded ring tones are labeled User 1 and User 2 in the choices for the Default Ring. On the phone ring tone menu, the User 1 and 2 choices are replaced by the corresponding name of the ring tone. “Not Installed” appears if the user ring tone slots are not used.

For ring tone User 1 and User2, the cadence is fixed with the on-time equals to the duration of the ring tone file and off-time equals to four seconds. The total ring duration is fixed at 60 seconds. The user ring tone names displayed on the phone LCD are derived from the ring tone file header file.

The phone does not require rebooting after downloading a ring tone.

To remove the User 1 ring tone from the phone, set the path to delete, as follows:

http://phone_ip_addr/ringtone1?/delete

To convert a file for use as a ring tone, obtain a .wav file less than 8 seconds in length and convert it using the Upload Ringtone utility available from the following website:

http://www.linksys.com/support

Linksys SPA9x2 Phone Administration Guide 93