Lucent Technologies 610, 310 manual Batteries and chargers, Dual Chargers, Cleaning the Chargers

Page 24

Batteries and chargers

7.3

Dual Chargers

The Dual Charger is a two-slot desktop charger.The Dual chargers are designed to charge the IP Touch WLAN and a spare Battery Pack.

Place the handset face forward into the Dual Charger front slot. Place a spare Battery Pack in the rear slot, charging contacts down. The front slot takes charging precedence. The Battery Pack in the rear slot will begin charging when the handset in the front slot is fully charged or when the front slot is empty.

„Indicator light

An LED on steady indicates that the spare battery is charging. A flashing LED indicates spare battery charging malfunction (insert the spare battery again or change it). When the LED is off, this means that the charging of the spare battery has terminated, that the compartment is empty or that the charger is not connected to the mains.

„Charge Complete

When the IP Touch WLAN is fully charged, Charge Complete will display.

7.4

The Gang Charger - only on Mobile IP Touch 610 WLAN

The Gang Charger is designed to charge four Battery Packs simultaneously. Chargers operate in a 50° to 85° F (10° to 30° C) environment. Do not expose them to freezing temperatures or direct sunlight.

The Gang Charger is shipped with the appropriate power supply for the site’s location. Place the Gang Charger on a flat, horizontal surface. Plug the power supply into the Gang Charger and into an appropriate wall outlet.

„Using the GC

Insert the Battery Pack into one of the four charging bays so that the Battery Pack contacts meet the charging bay contacts. The LED above the charging bay will turn on to indicate that charging is in progress. When charging is complete the LED will turn off. Lift the Battery Pack out of the charging bay.

„Blinking LED

If the LED starts blinking as soon as the Battery Pack is inserted, the Battery Pack may be improperly seated. Lift it out and reinsert. If the LED continues to blink or starts blinking at any time during the charging process, it indicates that there is a problem with the Battery Pack that makes it unusable. Do not continue to charge the Battery Pack. Dispose of it properly and do not attempt to use it in the IP Touch WLAN. Do not attempt to open or repair a defective Battery Pack. Contact your service representative for assistance. If the LED is on steady, this means the charger is defective. Contact your administrator.

7.5

Cleaning the Chargers

Clean the Chargers by wiping the surface with a clean, water-dampened cloth or paper towel. A mild detergent solution may be used. Be sure to wipe away any detergent residue with a plain water dampened cloth. DO NOT IMMERSE THE CHARGER IN WATER OR OTHER LIQUID. DO NOT POUR LIQUIDS INTO THE SLOT.

The Battery Pack contacts on the IP Touch WLAN may be cleaned with isopropyl (rubbing) alcohol applied with a Q-tip, cloth, or paper towel. Do not push or pull the exposed Battery Pack contacts.

•Important information

•Never use non-IP Touch WLAN charging units as they could damage the Battery Pack.

•Only use the original plug-in power adapter for the Chargers.

•Do not immerse the Battery Pack in water or throw into the fire.

•Do not throw away the Battery Pack with your domestic waste. Take used Battery Packs to an appropriate collection point for recycling or send them back to your supplier or servicing agent.

•Replacement Battery Packs are available from your supplier or servicing agent.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Handset Page How to use this guide IntroductionPage Contents Getting to know your telephone Using your telephone Make a call using the personal phone bookUsing your telephone Sending Dtmf signalsMake a call-back request to a busy number Mute, so that your correspondent cannot hear youSwitching between calls Broker call During a conversationAnswering a second call during a conversation Making a second call during a conversationDuring a conversation ConferencePlacing a call on hold hold Placing an outside call on hold parkingAdjust audio volume Intrusion into an internal conversationProtection against intrusion 3Sharing Answering the general bellCall pick-up Hunting groupsSharing Answering a call on your pagerCalling a correspondent on his/her loudspeaker Sending a written message to an internal correspondentSend a voice message to a destination Send a voice message copyPersonal code Spell the addressees nameDiverting your calls to your voice message service Keep in touchDiverting calls to another number immediate diversion While listening to messages, you canCancelling all diversions Diverting calls when your line is busy divert if busyKeep in touch Do not disturbLeaving a recorded message for internal callers Consulting written messagesTo complete Message To consultManaging your charges Charging your calls directly to business accountsModify the password for your phone set Programming your telephoneAdjusting screen brightness Programming your telephoneProgram a non-programmed entry in the personal phone book Selecting languageProgramming an appointment reminder Lock / unlock your telephoneModify a programmed entry in the personal phone book Activate/deactivate the Key tones Activate/deactivate the Warning tonesLocking the keypad Lock the keypad automaticallyBatteries and chargers BatteriesDesktop Charger Cleaning the Chargers Batteries and chargersDual Chargers Gang Charger only on Mobile IP Touch 610 WlanPush to Talk IP Touch 610 Wlan Adjusting the volume level of the tones Change PTT volumePush to Talk IP Touch 610 Wlan Guarantee and clauses „ Precautions for use„ Declaration of compliance „ Information relative to the environment
Top Page Image Contents