Lucent Technologies 308/616 installation instructions Run Cable To All Telephone Locations

■Run Cable To All Telephone Locations

Select a cable extension kit with the right length of cable (100 or 200 feet) for one cable run. For runs over 200 feet, run a 200-foot cable, terminate it in a modular connecting block, plug in another cable, and repeat, up to a maximum of 1000 feet.

Select a Cable Extension Kit with the right length of cable (100 or 200 feet) for one cable run. For runs over 200 feet, you will have to-run a 200-foot cable, terminate it in a modular connecting block, and plug in another cable. The maximum length of any cable run is 1000 feet.

If there is no plastic cable loop in place, slide a cable tie under the two “spiders” in each box.

Fill out a pair of wiring run labels wih the telephone location of the first wiring run (for example, W1 shop,

W2 sales, W3 RM. 105). Attach one label inside a jack panel door.

Save the second label for use on a modular connecting block.

Attach a cabel clip 6 to 12 inches below the lowest box to support each cable as you run it.

Plug in the cable connector on the right side. Thread the cable through the clip.

Run the cable out to the telephone location. Avoid sharp kinks or twists. Use cable clips or staples to dress the cable neatly along wall baseboards, molding, etc. Be careful not to damage the cable with staples.

Customer Installation Instructions 9