Wiring Runs | Lucent Technologies 308/616 guide

Step 4 Wiring Runs

You may choose to wire your SPIRIT Communications System using 4-pair “business” wiring materials or 2-pair “customer convenience” wiring materials. While the materials are somewhat different, the procedure for labeling the wiring run is the same.

Each “run” from the controller to a telephone set location should be numbered and labeled. Materials for labeling the telephone cords are included with the controller. Do not skip this important step.

If you choose to use the 4-pair “business” wiring materials, the labeling should look like the following:

Sample System Directory Label

	C o n t r o l l e r
10	11	12	13	Telephone Cord
				Telephone Cord
				Labels
				Labels

D8W-87

Jumper

Cords

Jack Panel box

D4BU Telephone Cord

Jack Panel Wiring

Run Label

Modjack/Modjack Adapters

Up to 1000’ length

of cable (8-conductor)

Modular

Connecting

Block

25’ Max.

Wiring Run

Labels

If you choose to wire your system with customer convenience wiring, use the wiring run

labels to label EACH END of EVERY cord, as well as the wire junction boxes.

Note to installers: The SPIRIT system requires a reversal in the station set wiring. This reversal is in the telephone (tinsel) cord that is packed with the telephone, so all other station set wiring should be straight.

6Customer Installation Instructions