Choosing Tone or Pulse Dialing

Then the display will ask you to set your Area Code (FIG. 3): While the first digit is flashing, you should:

1.Press the UP button till the first digit of your area code is displayed (flashing).

2.Press the DELETE button to accept and go to the next digit.

3.Repeat steps 1 and 2 above to set the 2nd and 3rd digits of your area code.

You do not have to set up the Time and Date because the telephone company will automatically update this with your Caller ID when your phone rings (twice or more). To

get back to the standby mode (for dialing), press the DELETE button repeatedly until the normal display shows.

AREA CODE EXAMPLE: 718

Press UP & DELETE to set

After setting the LCD contrast, language, area code, time & date, you can adjust the display to the proper position so that you can easy read the information in the display.

Select the type of dialing that your telephone system requires by setting the TONE/PULSE switch (on the rear of the telephone).

TONE - The set will operate using tone dialing.

PULSE - The set will dial using rotary dial type pulses (clicking sounds).

If you are not sure of your dialing system, make a trial call with the switch set to TONE. If the call connects, leave the switch as it is; otherwise, set it to PULSE.

NOTE: To use caller ID service, you will probably need TONE dialing.

MAKING CALLS

1.Pick up the handset or press the SPEAKERPHONE button to get a dial tone.

2.Dial your call.

3.To end the call, replace the handset on the base or press the SPEAKERPHONE button again.

ANSWERING CALLS

1.After the phone rings, the INCOMING CALL indicator will flash simultaneously, pick up the handset or press the SPEAKERPHONE button.

2.To end the call, replace the handset on the base or press the SPEAKERPHONE button again.

VOLUME CONTROL AND RINGER SETTING

Adjust the handset volume

Adjust the speakerphone volume

Adjust the ringer level

Slide the HANDSET VOLUME control (LOUD or NORMAL).

Slide the SPEAKERPHONE VOLUME control (on the right side of the phone).

Set RINGER HI/LO/OFF switch (on the rear of the phone). HI - loud rings on incoming calls.

LO - lower rings on incoming calls. OFF - no ringing on incoming calls.

5IB-PH5562-WM-E-010807

IB-PH5562-WM-E-010807.pmd	6			1/23/2007, 5:08 PM