Lenoxx Electronics PH-5562 Wall Mounting, Slide OUT Reverse Replace Into Phone

Page 9

WALL MOUNTING

NOTE: For either desk use or wall mounting, you need to install the included adaptor correctly. If you do not have a modular wall phone plate installed, please consult with your phone company or installer to get one.

1.HANDSET CLIP - When the phone is mounted on the wall, the HANDSET CLIP must be adjusted so it will hold the HANDSET.

A. SLIDE OUT

B. REVERSE

C. REPLACE INTO PHONE

2.Put the straight telephone line cord into the wall adaptor, leave one end of the telephone line cord about 7and the other end about 3.

ABOUT 7 INCHES

(plug into phone jack)

ABOUT 3 INCHES

(plug into wall jack)

3. Install the wall adaptor on the bottom of the base as the diagram on the right.

4.Plug the longer wire about 7into the top of the phone, plug the 3wire into wall jack.

5.Put the phone over the wall plate, make sure both posts fit into slots on the back of the phone. Then slide the phone down to lock the phone onto the wall plate.

8IB-PH5562-WM-E-010807

IB-PH5562-WM-E-010807.pmd

9

 

 

1/23/2007, 5:08 PM

 

 

 

 

 

Image 9
Contents Model PH-5562 Operating Instructions Memory Jumbo Display Caller ID SpeakerphoneImportant Safety Instructions Battery Safety Instructions Powering the Phone Checking the Package ContentsConnecting the Telephone Setting UP LCD CONTRAST, LANGUAGE, Area CODE, Time and DateAttaching the Bracket for Desk USE Choosing Tone or Pulse Dialing Volume Control and Ringer SettingMaking Calls Answering CallsPause Function Last Number RedialingHold Function Flash FunctionCaller ID Operation Using Message WAITING/MAILBOXViewing the Caller ID List Calling Back from the Caller ID ListSlide OUT Reverse Replace Into Phone Wall MountingCheck ProblemsProblemscheck Trouble ShootingImportant Telephone Company & FCC Information 12IB-PH5562-WM-E-010807 Limited Warranty