Clarity RC200 Channel Settings, Remote Transmitter Replace remote cover and test

CHAPTER 7 (CONTINUED)

CHANNEL SETTINGS

The RC and Remote Transmitter use radio signals to communicate with each other. For the Remote Transmitter to activate the RC, they both have to be on the same "channel." A "DIP Switch" is used for channel selection.

Your phone and remote have been preset at the factory to a standard channel setting. Under normal operating conditions, there is no adjustment necessary.

If your system encounters interference and repeatedly activates by itself for no obvious reasons, it may be necessary to change DIP Switch settings on the RC and Remote Transmitter.

ON

1 2 3 4 5 6 7 8

ON

1 2 3 4 5 6 7 8

S
E
T
T
	O
			M
				A
				T
				C
				H
		A	X	E
	C
T
L
Y

(Remove cover to expose switch)

1.Unscrew bottom of the Remote Transmitter.

2.Locate DIP Switches on Remote

Transmitter. and on bottom of

RC

3.Using a ball point pen, change the settings on all switch positions to match exactly on both RC

and Remote Transmitter.

4.Replace remote cover and test.

Figure 24 – Channel setup

13