Technicolor - Thomson 26955 manual FCC Registration Information

Page 2

FCC REGISTRATION INFORMATION

Your telephone equipment is registered with the Federal Communications Commission and is in compliance with parts 15 and 68, FCC Rules and Regulations.

1Notification to the Local Telephone Company

On the bottom of this equipment is a label indicating, among other information, the FCC Registration number and Ringer Equivalence Number (REN) for the equipment. You must, upon request, provide this information to your telephone company.

The REN is useful in determining the number of devices you may connect to your telephone line and still have all of these devices ring when your telephone number is called. In most (but not all) areas, the sum of the RENs of all devices connected to one line should not exceed 5. To be certain of the number of devices you may connect to your line as determined by the REN, you should contact your local telephone company.

Notes

•This equipment may not be used on coin service provided by the telephone company.

•Party lines are subject to state tariffs, and therefore, you may not be able to use your own telephone equipment if you are on a party line. Check with your local telephone company.

•Notice must be given to the telephone company upon permanent disconnection of your telephone from your line.

2Rights of the Telephone Company

Should your equipment cause trouble on your line which may harm the telephone network, the telephone company shall, where practicable, notify you that temporary discontinuance of service may be required. Where prior notice is not practicable and the circumstances warrant such action, the telephone company may temporarily discontinue service immediately. In case of such temporary discontinuance, the telephone company must: (1) promptly notify you of such temporary discontinuance; (2) afford you the opportunity to correct the situation; and (3) inform you of your right to bring a complaint to the Commission pursuant to procedures set forth in Subpart E of Part 68, FCC Rules and Regulations.

The telephone company may make changes in its communications facilities, equipment, operations of procedures where such action is required in the operation of its business and not inconsistent with FCC Rules and Regulations. If these changes are expected to affect the use or performance of your telephone equipment, the telephone company must give you adequate notice, in writing, to allow you to maintain uninterrupted service.

INTERFERENCE INFORMATION

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pur suant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna (that is, the antenna for radio or television that is “receiving” the interference).

•Reorient or relocate and increase the separation between the telecommunications equipment and recei ving antenna.

•Connect the telecommunications equipment into an outlet on a circuit different from that to which the receiving antenna is connected.

If these measures do not eliminate the interference, please consult your dealer or an experienced radio/ television technician for additional suggestions. Also, the Federal Communications Commission has prepared a helpful booklet, “How To Identify and Resolve Radio/TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402. Please specify stock number 004-000-00345-4 when ordering copies.

HEARING AID COMPATIBILITY

This telephone system meets FCC standards for Hearing Aid Compatibility.

2

FCC NUMBER IS LOCATED ON THE CABINET BOTTOM REN NUMBER IS LOCATED ONTHE CABINET BOTTOM

Page 1 Page 3
Image 2
Page 1 Page 3
Contents 26955 FCC Registration Information Table of Contents Memory Introduction Voice Messaging Make sure your package includes the items shown here Parts ChecklistBefore YOU Begin Corded handset Handset cord BaseTONE/PULSE switch InstallationDesktop Installation 115 Wall Mount Installation 156 Settings Prog buttonPress and release Prog again to store the language setting Setting the Local Area Code Press and release Prog until SET Time shows on the display Volume Control TalkRedial USE IndicatorCordless Phone Basics Check the display to see who is calling USE indicator Speaker buttonTelephone Operation Auto Standby Manual Channel SelectionDuration Counter Channel buttonRinger Volume switch Ringer Volume SwitchRinger switch FlashSpeaker button Last Number RedialTo redial the last number you dialed Hold indicator HoldButton Finding the HandsetMute Mute buttonPrivacy Mode Format buttonTemporary Tone Dialing Switch is set to PULSE, you can press the Tone button toTone button TONE/PULSE switch Format button Tone buttonRotary service On the keypad, when your callInformation. When you hang up Is answeredVoice Mail Speaker button indicator Voice MessagingSetting a NEW Security Code from the Base Mute indicator Hold button Mute buttonSetting a NEW Security Code from Cordless Handset Speakerphone Operation Using the Base Unit SpeakerphoneSpeaker indicator Speaker button Receiving a Call with Speakerphone Making a Call with SpeakerphoneSwitching Between Speaker and Handset Handset to Speaker Press SPEAKER, then hang up the handsetIntercom Operation Using IntercomIndicatorbutton Intercom CallingINT button Indicator Advanced Intercom FeaturesHook switch Using Intercom While YOU have a Telephone Call Button on the unit where Place your unit in Privacy modePress the Intercom or INT Outside call is in progressPAGE/INTERCOM button To answer the intercomPress the PAGE/INTERCOM button Make sure your unit is not in Privacy Mode Hold. At the baseSpeaker button Memory Memory button Storing a NAME/NUMBER MemoryMEM button Quick dial buttons Page Button Format button MEM button Review button Inserting a Pause Dialing SequenceREVIEWING, Changing or Deleting Stored Numbers Pause buttonDisplayed For deletion. The display showsDelete the entry. Deleted is Button MEM button Review button Dial buttonLift the corded handset, or press the Speaker button Dialing a Stored Number During ReviewDialing a Stored Number Speaker button Memory buttonDialing a Quick Dial Number Chain Dialing from MemoryMake sure the phone is on Press MEM and then press At the next access tone, press MEM and thenAt the next access tone, press Memory and then Caller ID Operation Receiving and Storing Call RecordsReviewing Call Records NEW Call # Dialing a Caller ID Number Review button Format buttonEleven digits Format Deleting the Current Caller ID Record Deleting ALL Caller ID RecordsCaller ID Errors Call Waiting Caller ID Changing the Battery Battery Safety Precautions Handset Sound Signals General Product CareMessage Indicators ErrorTroubleshooting Guide TelephoneBase and cordless Handset Battery Service Causes of Poor ReceptionForm OnlyorcompletethisPage Index Page Limited Warranty For how long after your purchaseModel Box 1976, Indianapolis, Rev DOM E
Top Page Image Contents