Engaging Automatic Set Relocation

NOTE: If this feature has been enabled by your system programmer, the mes- sage-waiting light will flash for several seconds when you corinect your telephone to another location. This means that the system Is waiting to automatically relocate your extension number and other programmed features to the new location.

If you do not want your telephone to have all of fts old programming after relocation, reject the automatic relocation.

l To accept automatic relocation,

do nothing and wait for the light to turn off on its own, or press the HOLD button to immediately accept the relocation (light immediately turns off).

l To reject the automatic relocation,

press the I button while the message waiting light is flashing.

Programming Your Telephone

l To store autodial numbers,

1.presslTCManddial**l,

2.press programmable button,

3.press line button, or dial 1,2,3, or 4, to select line groups 1 - 4, or dial 0 for system to select line,

4.dial number to be stored (16 digits max.)

l to store hookflash in an autodial sequence, press TAP; press HOLD to store pause (only if needed),

5.press TRANSICONF, then press next programmable button, and dial another number to be stored,

6.repeat previous step until finished then press SPKR.

NOTEr You can store an autodial number at a second level at a

DSS button if you wish.

lTo store extension numbers at DSS buttons,

1.press ITCM and dial +k * 3,

2.press programmable button,

3.dial extension number,

4.press next programmable button and dial another extension num- ber,

5.repeat previous step until finished then press SPKR.