HANDSET SOUND SIGNALS
Signal | Meaning |
One beep every 7 seconds
Three long beeps (with ringer on)
A long warbling tone (with ringer on) One long beep
Battery is low
Page signal.
Signals an incoming call.
Handset and Base are
not communicating: the handset might be too far away from the base, you might need to try another channel, or the base might not be receiving power.
A brief warbling tone | You've stored a number in memory |
| successfully. |
|
|
TROUBLESHOOTING GUIDE
In case of difficulty, please check the following Troubleshooting Guide before seeking service.
Problem | Solution |
|
|
No dial tone | • Check installation: |
|
|
| — Is the base power cord connected to a working |
|
|
| outlet? |
|
|
| — Is the |
|
|
| — Is the telephone line cord connected to the wall |
|
|
| jack? |
|
|
| • Disconnect the base from the wall jack and connect |
|
|
| another phone to the same jack. If there is no dial tone | ||
| in the second phone, the problem might be your |
|
|
| wiring or local service. |
|
|
| • Is the handset out of range of the base? |
|
|
| • Make sure the battery is properly charged (12 hours). |
|
|
| • Is the battery pack installed correctly? See page 9. |
|
|
| • Did the handset beep when you pressed the phone |
|
|
| button? Did the |
|
|
| battery may need to be charged. |
|
|
| • Reset the security code by placing the handset in the |
|
|
| base for about 20 seconds. | 11 | |