Radio Shack TAD-799 owner manual Connecting to the Telephone Line

Page 7

43-799.fm Page 7 Monday, August 16, 1999 9:43 AM

2.Snap the battery’s terminals to the connector inside the compartment.

3. Replace the cover.

When Lo and the two-digit number of calls in memory alternately flash on the display, replace the battery. When you replace the battery, be sure the TAD is connected to AC power so you do not lose any stored information.

Cautions:

•Dispose of old batteries promptly and properly. Do not burn or bury them.

•Always remove old or weak batter- ies. Batteries can leak chemicals that can destroy electronic parts.

CONNECTING TO THE TELEPHONE LINE

To connect the TAD to the phone line, plug one end of the supplied modular cord into the TEL LINE jack on the back of the TAD. Then plug the other end into a modular phone jack.

You can also connect a telephone to the TEL SET jack on the back of the TAD us- ing a second modular cord (not sup- plied).

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents TAD-799 Features Fm Page 3 Monday, August 16, 1999 943 AM FCC Statement Read this Before InstallationContents Installing Backup Battery InstallationChoosing a Location Connecting to the Telephone Line Connecting to Power Preparation Setting the DAY and TimeRecording the Outgoing Message Setting the TAD to Answer Calls Setting the Number of RingsBasic Operation Screening Calls Recording Incoming MessagesPlaying Messages Repeating Messages Recording a Memo Erasing MessagesRemote Operation Using TOLL-SAVERChanging the Remote Operation Security Code Remote ANSWER-ON Using Remote Commands Press Remote CommandsProblem Suggestion TroubleshootingCare and Maintenance Lightning FCC Wants YOU to KnowFm Page 22 Monday, August 16, 1999 943 AM Fm Page 23 Monday, August 16, 1999 943 AM RadioShack Division of Tandy Corporation Fort Worth, Texas
Top Page Image Contents