Radio Shack TAD-795 Using Call Breakthrough, Changing the Remote Operation Security Code

Page 14

43-795.fm Page 14 Monday, August 16, 1999 9:07 AM

USING CALL

BREAKTHROUGH

If you screen your calls but want to know when calls come in from certain people, give them your call breakthrough (CBT) code.

When a caller enters the CBT code dur- ing the outgoing message, the TAD alerts you with a series of loud beeps for 35 seconds. To answer the call, pick up the handset. If you do not answer, the caller can leave a message after the outgoing message plays.

Changing the CBT Code

The CBT code is preset to 648. Follow these steps to change it to a number from 500 to 999.

Note: Be sure to complete each step within 8 seconds. Otherwise, the TAD beeps four times and you must start over from Step 1.

1.Hold down CODE until the TAD beeps. Co (code) appears.

2.Press REPEAT. Cc (CBT code) ap- pears, and the TAD announces and shows the current code’s numbers in sequence. Then the first digit of the code reappears.

14

3.Repeatedly press SKIP or REPEAT to set the first digit, then press STOP. The second digit appears.

4.Repeatedly press SKIP or REPEAT to set the second and third digits, pressing STOP after each digit. The TAD beeps and announces the new CBT code.

CHANGING THE REMOTE OPERATION SECURITY CODE

The remote operation security code is preset to 795. Follow these steps to change it to a number from 500 to 999. Do not use the same number you chose for the CBT code.

Note: Be sure to complete each step within 8 seconds. Otherwise, the TAD beeps four times and you must start over from Step 1.

1.Hold down CODE until the TAD beeps. Co (code) appears.

2.Press CODE again. Sc (security code) appears, and the TAD an- nounces and displays the current code’s numbers in sequence. Then the first digit of the code appears.

3.Repeatedly press SKIP or REPEAT to set the first digit, then press STOP. The second digit appears.

4.Repeatedly press SKIP or REPEAT to set the second and third digits, pressing STOP after each digit. The TAD beeps and announces the new remote operation security code.

Image 14
Contents TAD-795 Features LED Message Counter shows Read this Before IN- Stallation FCC StatementContents Connecting the AC Adapter PreparationInstalling a Backup Battery Setting the DAY and TimeRecording the Outgoing Messages Setting the Number of Rings Checking the Outgoing MessagesIncoming Message Recording Setting the TAD to Answer CallsBasic Operation Screening Calls Playing MessagesDeleting Messages Recording a Memo Recording a ConversationUsing Call Breakthrough Changing the Remote Operation Security CodeRemote Operation Using the TOLL-SAVERUsing Remote Commands Remote Commands Troubleshooting Resetting the TADCare and Maintenance FCC Wants YOU to Know LightningRadioShack Division of Tandy Corporation Fort Worth, Texas