Radio Shack ET-1126 owner manual Important Safety Instructions

Page 6

43-1126.fm Page 6 Thursday, April 27, 2000 11:23 AM

IMPORTANT SAFETY

INSTRUCTIONS

When using your telephone equipment, ba- sic safety precautions should always be fol- lowed to reduce the risk of fire, electric shock and injury to persons, including the following:

1.Read and understand all instructions.

2.Follow all warnings and instructions marked on the product.

3.Never install telephone wiring during a lightning storm.

4.Never install telephone jacks in wet locations unless the jacks are specifi- cally designed for wet locations.

5.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the net- work interface.

6.Use caution when installing or modifying telephone lines.

7.Do not affix the AC power supply cord to building surfaces with metal fittings (if the product has an AC power cord).

8.Unplug this product from the wall outlet before cleaning. Do not use liquid clean- ers or aerosol cleaners. Use a damp cloth for cleaning.

9.Do not use this product near water. For example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.

10.Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product.

11.Slots and openings in the cabinet and the back or bottom are provided for ven- tilation. To protect the phone from over-

heating, the openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation unless proper ventilation is provided.

12.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your local power com- pany.

13.Do not allow anything to rest on the power cord. Do not locate this product where the cord will be stepped on.

14.Do not overload wall outlets and exten- sion cords. Doing so can result in a risk of fire or electric shock.

15.Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.

16.To reduce the risk of electric shock, do not disassemble this product. Take it to a qualified serviceman when service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incor- rect reassembly can cause electric shock when the product is subsequently used.

17.Unplug this product from the wall outlet and refer servicing to qualified service technicians under these conditions:

When the power cord plug is dam- aged or frayed.

6

 

Features

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 6
Contents With Caller ID and Call Waiting ID Contents Troubleshooting Care and Maintenance Features Read this Before Installation Important Caller ID InformationFCC Statement Important Safety Instructions Battery Safety Instructions Save These InstructionsInstallation Mounting the PhoneOn a Desk Top, Shelf, or Table On a Wall Plate or Wall Connecting and Charging the Battery Pack Quick Look AT the Handset Press Delete to erase information if you make a MistakeSetting the Dialing Mode Setting the Ringer TONE/VOLUMETurning Auto Talk ON/ OFF Storing Your Area Code OperationTurning Caller ID/ Call Waiting ON/OFF Making and Receiving CallsUsing Speakerphone Using HoldUsing Redial Using MuteUsing Flash Using Tone Services on a Pulse LineTransferring a Call Between the Handset and Base Using PAGE/INTERCOMMemory Dialing Storing a Number in the Handset’s MemoryEditing or Deleting a Number in the Handset’s Memory Reviewing the Handset’s Memory Numbers Storing a Number in the Base’s MemoryEntering a Pause Dialing a Memory NumberTesting Stored Emergency Num- bers Using a HeadsetChain-Dialing Service Numbers Caller ID OperationCaller ID Messages Adding/Deleting the Area CodeDialing Numbers from a Caller ID Record Storing a Caller ID Record to Memory Deleting Caller ID RecordsTroubleshooting Fm Page 23 Thursday, April 27, 2000 1123 AM Care and Maintenance Replacing the Battery Pack FCC Wants YOU to Know LightningFm Page 27 Thursday, April 27, 2000 1123 AM Limited One-Year Warranty