Installation
4'%*#4)+0)"6*'"$#66'4;"2#%-
•If the CHARGE/IN USE indicator does not light when you place the handset on the base, be sure the battery pack and AC adapter are correctly and securely con- nected. Also, check the charging contacts on the hand- set and the base. If the contacts are dirty or tarnished, clean them with a pencil eraser.
•When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear an error tone. Return the handset to the base for about 3 seconds to reset the security
•If the battery pack becomes weak during a call, the handset beeps every 3 seconds and TALK/BATT flashes. When this happens, recharge the battery pack.
•If TALK/BATT does not light and the phone does not work, recharge the battery pack. (The battery power might be too low to light TALK/BATT.)
•About once a month, fully discharge the battery by keeping the handset off the base until TALK/BATT flashes. Otherwise, the battery pack loses its ability to fully recharge.
•The handset loses its security
•If you are not going to use your phone for an extended period, disconnect the battery pack. This increases the battery pack’s usable life.
The supplied battery pack should last for about a year. If the battery pack does not hold a charge for more than 2 hours after an overnight charge, replace it with a new
5'66+0)"6*'"4+0)'4"610'
You can select either a high or low ringer tone setting on the handset while the phone is not in use. Lift the handset and press VOL/RING to hear the current ringer setting. Repeat- edly press VOL/RING to select the desired ringer setting.
5'66+0)"6*'"&+#.+0)"/1&'
Your phone is set for tone dialing. If you have pulse service, change the dialing mode. If you are not sure which type of service you have, do this test.
6