100%6+0#0&%*#4+06*$#664 2#%, Installation

To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the back of the base. Drill two holes 315/16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads extend about 1/8 inch (3 mm) from the wall.

1. Plug one end of the supplied modular cord (long for a desktop or direct wall mounting, short for a wall plate) into the TEL LINE jack on the bottom of the base.

2. Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the bottom of the base and route the adapter’s cord through the strain relief slot on the base.

3. Route the adapter and modular cords through the molded routing channels

on the back of the base as Modular shown here.

Cord

4. For a wall plate, plug the other end of the short modular cord into the wall plate jack.

AC Adapter Cord

5.For a wall plate or direct wall

mounting, align the base’s keyhole slots with the wall plate studs or mounting screws and slide the base down to secure it.

6.For a desktop or direct wall mounting, plug the other end of the modular cord into a modular phone line jack.

7.Plug the adapter into a standard AC outlet.

%100'%6+0)"#0&"%#4)+0)"6'"$#66'4;" 2#%-

The phone comes with a rechargeable nickel-cadmium battery pack in the handset, but not connected. Before using your phone, you must connect the battery pack, then charge it for about 15–20 hours. #

1.Press down and slide off the battery compartment cover in the direction of the arrow to remove it.

2.Lift the battery pack out of the compartment.

3.Plug the battery pack’s connector into the socket in the compartment (the connector fits only one way), then place the battery pack in the compartment.

4.Replace the cover.

To charge the battery pack, place the handset on the base. The CHARGE/IN USE indicator on the base lights. Recharge the battery pack when the handset beeps and TALK/BATT flashes. R

#"+/2146#06"# The EPA certified RBRC® Battery Recycling Seal on

the nickel-cadmium (Ni-Cd) battery

indicates RadioShack is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800- THE-SHACK (1-800-843-7422) for information on Ni-Cd battery recycling and disposal bans/ restrictions in your area. RadioShack’s involvement in this program is part of the company’s commitment to preserving our environment and conserving our natural resources.

R"9#40+0)ýR"

Dispose of the old battery pack promptly and properly. Do not burn or bury it. See “Battery Safety Instructions” on Page 3 for additional information on proper battery handling.

%100'%6+0)"#0&"%*#4)+0)"6*'"$#66'4;" 2#%-

Installation

%100'%6+0)"#0&"%#4)+0)"6'"$#66'4;" 2#%-