Installing Optional Accessories

Installing Optional Accessories

The XC Series ships with a battery temperature sensor (BTS) and drip protection rubber boots for the DC cables.

Battery Temperature Sensor

Xantrex strongly recommends that you install a Battery Temperature Sensor (BTS) to protect your battery and improve charging accuracy. It is best to use a separate BTS with each individual battery bank, to provide optimal charging and protection of each bank. If no BTS is connected, the charger defaults to the charging conditions for 40 °C (104 °F). At this temperature the charging voltage is lower to keep batteries from overcharging; charging will be slower and the batteries will be slightly undercharged.

One BTS is provided with with your XC Series and additional battery temperature sensors may be purchased separately.

To install a BTS:

1.Switch off all devices operating from the battery.

2.Connect the ring terminal on the sensor directly on to the negative battery stud, or affix the double-sided adhesive backing (included) to the sensor back and attach the sensor to the side of the battery to be monitored.

3.Route the sensor cable to the charger and plug it into the bank 1 (default if using only one BTS), bank 2 or bank 3 connector on the rear panel.

975-0187-01-01

2–13

Page 39
Image 39
Xantrex Technology XC1524, XC5012, XC2524 Installing Optional Accessories, Battery Temperature Sensor, To install a BTS