
Installation
To remotely mount the display:
1.Remove the display as described on page
2.Secure the blank plate in the display socket as described.
3.Ensure that the extension cable used for the remote display is long enough to suit the installation. A standard North American style, 4 conductor
4.Use the enclosed mounting template to cut a hole for the display in the chosen mounting surface.
Take care that there is nothing behind the surface for you to damage.
5.Feed the remote display extension cable through the hole and route it to the charger. Be careful not to damage the telephone connector locking tab when routing the cable. You can use some tape to protect the locking tab from catching on something and breaking off when routing the cable.
6.Remove the adhesive backing on the back of the display.
7.Line up the display with the mounting hole.
8.Firmly press the flanges in place. Do not press in the middle of the display.
9.Once the XC Series is mounted, plug the cable into the bottom connector on the rear panel of the XC Series.
10.Proceed to “Mounting”.
Mounting
Mount the XC Series using the mounting slots provided.
For marine installations, only the mounting configurations with a check mark in Figure
Important: Be sure to measure your AC and DC cables and plan the routing of the cables before drilling the pilot holes for mounting the XC Series.
To mount the XC Series:
1.Keep the carton and packing material in case you need to return the XC Series for servicing.
2.Ensure that you have selected a mounting surface that is clear, flat and allows for a minimum of 76 mm (3 in.) of clearance on each end for fan circulation.