Xantrex Technology XC5012, XC2524 To connect AC wires with the crimp-on butt-splice connector

Installation

To connect AC wires with the crimp-on butt-splice connector:

Important: You must exercise care when crimping butt-splice connectors. Use the crimp tool recommended by the manufacturer for the connector used.

a)Using a wire stripper, carefully strip 8 mm (5/16 in.) from the ends of the two wires being connected.

b)Insert one wire into one end of the butt-splice, until the insulation hits the internal metal crimp section, insert the butt-splice into the crimping tool, and crimp firmly. The proper location for the crimp is approximately

1.6 mm (1/16 in.) past where the butt-splice insulation tapers down as shown.

STRIP 5/16”

1/16 “

CRIMP TOOL

c)Repeat Step b for the other end of the butt-splice.

11.Push the AC cable strain relief into the electrical junction box hole until it snaps into place.

12.When all connections are completed, push the wiring and connectors inside the wiring compartment. Install the wiring compartment cover and fasten with the supplied blunt-tip screws and lockwashers.

2

1

13.Proceed to “Mounting the Remote Display”.

2–6 975-0187-01-01