Xantrex Technology XC2524, XC5012, XC3012 Tools and Materials, You need the following materials

Preparing for Installation

Tools and Materials

To mount and connect the XC Series you need the following tools:

•10 mm wrench or socket for the DC terminals and ground stud

•Phillips screwdriver for securing the AC wiring compartment cover

•power drill

•drill bit for pilot holes for mounting screws

•wire stripper

•manufacturer's recommended crimp tool for any crimp terminals that are being used

You need the following materials:

•3 conductor AC input wiring

Use the information in “AC Wiring” on page 1–13 and your local electrical codes to determine the correct wire and breaker or fuse.

•AC cable strain relief (if the one included is not sufficient for your local electrical code requirements)

•appropriately sized DC cables for each battery, with suitable connectors at the battery end

•appropriately sized DC chassis ground (earth) with suitable connectors

•ring terminals to fit 6 mm (1/4 in.) studs at the charger end

•DC fuse and disconnect or circuit breaker for each battery bank

•mounting hardware, 3 mm (#6) corrosion resistant 6 pieces.

•other means to route and secure AC and DC wiring

975-0187-01-01 1–9