To configure the charging type | Xantrex Technology XC3012, XC5012

Installation

To configure the charging type:

1.	Press and hold MODE until	(setup) is displayed.
2.	Press MODE to select 2-stage (		) or 3-stage ( ) charging. When you have
	selected a charging type that is different from the present configuration, the
	bank indicator light flashes.
	See “About Charging” on page 3–2.
3.	Press and hold ON/STANDBY until		is displayed to store the selected mode.

4. At any time during setup, youset2stcan yespress ON/STANDBY3stonce to cancel the current change and return to charging or battery monitoring.

2–16	975-0187-01-01

Image 42

Xantrex Technology XC3012, XC5012, XC2524, XC1524 manual To configure the charging type

Contents

Battery Charger Owner’s GuidePage Xantrex XC3012, XC5012 XC1524 and XC2524 Battery Charger Date and Revision Audience PurposeScope Organization Conventions Used Related Information Important Safety Instructions Explosive Gas and Battery Precautions FCC Information Viii Contents Troubleshooting SpecificationsOperation Introduction XC Series provides the following standard features XC Series provides the following protection features XC Series Appearance XC Series Information Centers of the XC Series Remote Display Information Centers of the XC Series CHf Onboard Status Panel Rear Panel Description Preparing for Installation 5XC Series System Tools and Materials You need the following materials Location Condition Requirement 6XC Series Mounting Orientations Wiring Requirements DC Wiring AC Wiring Over-current protection disconnect Battery Bank Size Requirements Installation Installing the XC Series Installation Sequence Pre-Installing DC Wiring To install DC wiring Pre-Installing AC Wiring To install AC wiring Conductor Color code To connect AC wires with the crimp-on butt-splice connector Mounting the Remote Display To remove the displayTo secure the display or blank plate on the unit Mounting To remotely mount the displayTo mount the XC Series Grounding Final Connections Shows the connection order Final DC Connections To make the last DC connections Powering Up To make the last AC connections Installing Optional Accessories Battery Temperature SensorTo install a BTS Drip Protection Rubber Boots To install rubber boots Configuring the XC Series To configure the battery bank type To configure the charging type Operation About Charging Multiplex 3-Stage Charging To force a battery detection sequence Sequential 2-Stage ChargingCharging Overview Temperature Considerations Disqualified Batteries Things to be aware Perform these disqualification checks in the order shown Charging Batteries To charge your batteries Charging Batteries Equalizing Flooded Batteries About Equalizing Performing An Equalization To equalize your batteries There are two ways to turn the XC Series on Transitioning the XC Series to On, Disabled or OffThere are two ways to disable the XC Series There is only one way to safely turn the XC Series off Accessing Charger Information Reading Remote Display and Onboard Status Indicator Lights ABS Cerr Reporting While Charging or Equalizing Reporting While Battery Monitoring Reporting While DisabledTo view the present status of the banks Using a Generator As Source Power Page Troubleshooting Care and Maintenance To clean battery terminals Indicator Light Flashing Sequences 1Indicator Light Sequences on the XC Series Error Messages on Remote Display 2Error Messages Err Bat Problem Solving Symptom Fault indicator light flashes. XC Series stops functioning Rdy Page Specifications Physical Specifications Electrical Specifications AC Input Specifications AC Input Specifications Temperature Specifications Protection Features Approvals EMCPage Warranty and Product Information Limited Warranty for Disclaimer of Warranty Return Material Authorization Policy Information About Your System Page Xantrex Technology Inc