Radio Shack Two-Line Caller ID Phone With Speakerphone owner manual Disabling the Line 2 Indicator

Page 12

43-935.fm Page 12 Friday, January 14, 2000 3:07 PM

DISABLING THE LINE 2 INDICATOR

If you have only one telephone line, the LINE 2 indicator lights and LINE 2 EX- TENSION appears on the display. Follow these steps to disable the LINE 2 indica- tor.

1.Press REVIEW 8 or 9 repeatedly until the call total appears.

2.Press REVIEW 9 until LINE 2 EN- ABLED appears (about 3 seconds).

3.Press REVIEW 8 or 9. LINE 2 DISABLED appears.

4.Press DELETE to return to the cur- rent time display.

ADJUSTING THE DISPLAY CONTRAST

1.Press REVIEW 8#or 9 repeated- ly until the call total appears.

2.Press and hold down REVIEW 8 for about 3 seconds until CONTRAST X appears.

3.Within 30 seconds, repeatedly press REVIEW 8 or 9 to adjust the dis- play’s contrast from 1 to 8.

Notes:

If CONTRAST X disappears before you press REVIEW 8 or#9, re- peat Steps 1–3.

If you did not connect an AC adapter, you can only adjust the display contrast from 1 to 3, and

12

only after you pick up the hand- set.

4.When you finish adjusting the con- trast, press DELETE to return to the main display.

SETTING THE RINGER VOLUME

To set the ringer’s volume for LINE 1 or LINE 2, set the correlating L1 RINGER or L2 RINGER to HIGH, LOW, or OFF.

Note: You can still answer calls if you hear an extension phone ringing, and you can still make calls.

SETTING THE DIALING MODE

Set TONE/PULSE for the type of service you have, tone or pulse. If you are not sure which type you have, do this test.

1.Set TONE/PULSE to TONE.

2.Pick up the handset and listen for a dial tone.

Image 12
Contents Two-Line Caller ID Phone Features Read this Before Installation Important Caller ID InformationImportant Safety Instructions FCC StatementBattery Safety Instructions Fm Page 6 Friday, January 14, 2000 307 PM Contents Installing Batteries PreparationSelecting a Location Mounting the SystemAttaching the Stand On a Desk Top On a Wall PlateOn the Wall Connecting Handset Connecting AC PowerDisabling the Line 2 Indicator Adjusting the Display ContrastSetting the Ringer Volume Setting the Dialing ModeInitializing System Adjusting the Handset Volume Using the SpeakerphoneOperation Making and Receiving CallsUsing Mute Using RedialUsing Flash Using HoldIdentifying Indicators Ringer IndicatorsDisplay and Light Indicators Using Caller ID Caller ID Display InformationError Reviewing Call RecordsArea Code Dialing Numbers In Call RecordsMemory Dialing Deleting Call RecordsStoring Call Records Into Memory Locations Storing a Pause In MemoryStoring Numbers Into Memory Storing Call Records Into MemoryStoring Special Service Numbers Using the Quick Reference CardStoring the Last Number Dialed Into Memory Using the Memory Card Deleting Stored NumbersReviewing Stored Numbers Dialing Stored NumbersTroubleshooting Problem SuggestionCare and Maintenance FCC Wants YOU to Know LightningFm Page 27 Friday, January 14, 2000 307 PM RadioShack Division of Tandy Corporation Fort Worth, Texas