Radio Shack 43-3823 owner manual On a Wall Plate or Wall

Page 8

Installation

3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back.

4.Route the adapter’s cord through the strain relief slot on the base’s bottom.

5.Plug the adapter into a standard AC outlet.

6.Lift the base’s antenna to a vertical position.

On a Wall Plate or Wall

To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the base. Drill two holes 315/16 inches apart. Thread a screw into each hole, letting the heads extend about 1/8 inch.

1. Insert the two tabs at the top of the narrow end of the supplied bracket into the base’s upper tab slots, then press down on the bracket’s latches and insert them into the lower slots.

2. Plug one end of the supplied modular cord (short for a wall plate, long for direct wall mounting) into the TEL LINE jack on the base’s back.

	3. Insert the	DC IN 9V	TEL LINE
	supplied AC	DC IN 9V	TEL LINE
	supplied AC
	adapter’s barrel
	plug into the DC
	IN 9V jack.

4. Route the adapter and modular cords through the base’s grooves.

8

Image 8

Contents 4GHz Cordless Phone With Answering MachineImportant Safety Instructions ContentsContents Battery Safety Instructions Read this Before Installation IntroductionIntroduction Mounting the Phone InstallationOn a Desk Top On a Wall Plate or Wall CONNECTING, Charging and Replacing the Battery Pack Installation Depending on your dialing system, set the mode as follows Recycling Ni-Cd BatteriesOperation Making and Receiving CallsTemporarily Mute Ringer Earpiece VolumeHandset Ringer Tone Flash and Call Waiting Traveling OUT-OF-RANGESelecting a Different Channel Memory Dialing Storing Phone Numbers in MemoryMaking Calls with Memory Dialing Chain DialingTesting Stored Emergency Numbers Erasing a Stored Number from MemoryONE-TOUCH Speed Dial Storing the Speed Dial ÔDeleting the Speed Dial Integrated Answering DeviceMaking Calls with the Speed Dial Features Turning the Answering SystemUsing the Menu Mode Setting UP Your Answering SystemSetting the Time Setting a Personal Security Code PIN Setting the Ring TimeAnnounce only feature Selecting the message Record TimeSetting the Message Alert tone Selecting the Language Setting Your Outgoing Message Greeting Preset messageRecording a personal outgoing message Greeting Ô Choosing between the two outgoing messagesTemporarily Mute the Base Ringer Setting the base ringer volumeAdjusting the speaker volume level Repeating a message Using Your Answering SystemPlaying your messages Skipping a message Deleting a messageVoice memo Recording a conversationRemote access away from home Command FunctionTurn on the answering system remotely Installing the Optional Beltclip Headset InstallationAdditional Information To attach the beltclipTroubleshooting Problem SolutionIncoming messages may be too long. Remind callers to Care FCC StatementSurge Protection FCC StatementPage Page Page Limited One-Year Warranty