>_]^, H_d][hJof[ý7ýBem, H_d][hýJof[ý8ý>_]^, orý H_d][hýJof[ý8ýBemýappears.
TURNING THE BASE’S RINGER ON/OFF
You can set the base’s ringer to high or low, or turn it off.
1.Press MENU four times. The phone announces “Ringer volume” and its current setting. The current setting also displays.
2.Press SET to enter the setting mode.
The system exits the setting mode when you:
•wait more than 20 seconds between key presses
•receive an incoming call
•press PLAY/STOP
•press TALK on the handset
Start again at Step 1.
3.Press SKIP/; or :/REPEAT to change the setting. The system announces the setting and displays >_, Be, or E<.
4.Press SET to store the setting.
5.Press PLAY/STOP to exit the menu setting.
Even when you turn off the base’s ringer, you can still make or receive calls using this phone. Telephones on the same line (and the handset if it is away from the base) still ring when there is an incoming call.
SETTING AUTO TALK
Your phone is preset so you must press TALK to answer a call. With auto talk turned on, you can answer a call by lifting the
handset from the base or, if the handset is away from the base, by pressing any key.
To turn auto talk on or off:
1.Lift the handset and hold down CALL ID until the setup menu appears.
2.Press SELECT to change the auto talk setting. Ed or E\\ appears.
3.To clear the display when you finish, press CALL ID or return the handset to the base.
TURNING CALLER ID/CALL WAITING ON/OFF
If you have Call Waiting and Caller ID service, you can set the system to show Caller ID information for an incoming call even while you are on the phone.
To set the Caller ID/Call Waiting:
1.Lift the handset and hold down CALL ID until the menu appears.
2.Press 2 or 9 to select 9?:9Mý(Caller ID/ Call Waiting).
3.Press SELECT to change the Caller ID/ Call Waiting setting. Ed or E\\ appears.
4.Return the handset to the base to store the new setting.
STORING YOUR AREA CODE
You can store your local area code in the phone’s Caller ID record so it does not show the area code if the received call is from your local area. If for some reason you need to dial the area code (or store in the memory), you can add it afterwards. “Adding/Deleting the Area Code” on Page 16.
10 | Installation |