Radio Shack 43-3814 owner manual Using Remote Commands, Using the Toll-Saver

Page 22

5.Press PLAY/STOP.

To check your code at any time, press MENU three times. The code appears, and the system announces it.

Using the Toll-Saver

If the ring time is set to jI (toll-saver) (see “Setting the Number of Rings” on Page 18), the system answers after two rings if you have new messages (ones you have not listened to). If there are no new messages, the system answers after four rings so you can hang up before the system answers and avoid unnecessary long-distance charges. If the message memory is full however, the system answers after about ten rings regardless of the ring time setting.

USING REMOTE

COMMANDS

While in remote operation, the system stops all answering functions and displays h9. Answering functions resume when it is no longer in remote command, if you have not turned the system off.

The remote operation stops when someone picks up the handset or any phone on the same phone line.

Follow these steps to operate the answering system from a remote location.

Note: If you wait more than 15 seconds between each keypress, the system sounds a long beep and hangs up.

1.Dial your phone number and wait for the system to answer. If the system is not set to answer calls, it will answer after about ten rings and sound a series of beeps.

2.When the outgoing message begins (or the system sounds a series of beeps),

press #, then enter your security code within 2 seconds.

3.If the code is correct, the system announces the number of new and old messages, then “To play incoming message, press pound two. For help, press pound zero.”

If the system does not respond, try entering your code again. If you enter an incorrect code three times, the system beeps and disconnects.

4.While the system is beeping, press # and (within 2 seconds) the number for the command you want.

22

Answering System Operation

Page 21 Page 23
Image 22
Page 21 Page 23
Contents MHz Cordless Phone Contents Answering System Operation Important Safety Instructions Introduction Important Caller ID InformationTelephone Highlights InstallationMounting the Phone Answering System HighlightsOn a Desk Top On a Wall Plate or WallCONNECTING, Charging and Replacing the Battery Pack Setting the Dialing Mode Setting the HANDSET’S Ringer TONE/VOLUMETurning Caller ID/CALL Waiting ON/OFF Setting Auto TalkTurning the BASE’S Ringer ON/OFF Storing Your Area CodeMaking and Receiving Calls Telephone OperationSelecting a Language Selecting the ChannelUsing Redial Setting the Handset VolumeUsing Flash Using Tone Services on a Pulse LineMemory Dialing Storing a Name and Number in MemoryEntering a Pause Chain-Dialing Service NumbersEditing or Deleting a Number in Memory Reviewing Memory NumbersCaller ID Operation Testing Stored Emergency NumbersReviewing Caller ID Records Storing a Caller ID Record in Memory ADDING/DELETING the Area CodeDialing Numbers from a Caller ID Record Deleting Caller ID RecordsSetting the DAY/TIME Using the Menu ButtonAnswering System Operation Setting the Record Time Setting the Number of RingsSelecting the Outgoing Message Screening Calls Setting the System to Answer CallsRECORDING/DELETING AN Outgoing Message Recording Incoming MessagesRecording a Conversation Recording a MemoPlaying Messages Deleting Messages Adjusting the VolumeSetting the Security Code Remote OperationUsing Remote Commands Using the Toll-SaverRemote Commands Press ThenTroubleshooting Problem SuggestionTroubleshooting FCC Wants YOU to Know CareFCC Statement LightningTelephone or power lines can damage your telephone Limited One-Year Warranty
Top Page Image Contents