Radio Shack 43-3595 Memory Dialing, Choosing the Dialing Mode, Storing Phone Numbers and Names

Page 19

Choosing the Dialing Mode

Most phone systems use tone dialing which sends DTMF tones through the phone lines. However some phone systems still use pulse dialing such as in rural areas. Ô

The default setting is tone dialing. Depending on your dialing system, set the mode as follows:

1.When the phone is in the standby mode, press and hold CID/MENU.

2.Press VOL/ key three times to select

Dial.

3.Press CH/SEL to toggle between Tone and Pulse for each setting.

4.Press END and return the handset to the base unit to complete the setting. The handset returns to the standby mode.

•If you are not sure of your dialing system, set for tone dialing. Make a trial call.

If the call connects, leave the setting as is, otherwise set for pulse dialing.

•If your phone system requires pulse dialing and you need to send the DTMF tones for certain situations during a call, you may “switch-over” to tone dialing. (Refer to “Tone Dialing Switch-over” on page 16.)

MEMORY DIALING

STORING PHONE NUMBERS AND NAMES

Memory Dialing allows you to dial a number using just a few key presses. Your cordless

Ô NOTE Ô

Dialing mode can only be changed from handset 1 (HS1).

To confirm which handset is HS1, look at the display indicating HS1 or HS2.

Memory Dialing

19

Image 19

Contents MHz Cordless Telephone Introduction IntroductionFCC Statement InformationSurge Protection Important Safety Instructions Important Caller ID Information Selecting a Location InstallationOn a Wall Plate or Wall Installing the Charging CradleLift the battery pack out of the compartment CONNECTING/CHARGING the Battery PackCHARGE/IN USE or OWARNING o Before USING, Register Extra Handset to Main Base UnitWhen to RE-REGISTER Handsets To transfer a call to the second handset Call Transfer FeatureMaking and Receiving Calls OperationEarpiece Volume Handset Ringer Tone VolumeAdjusting the Handset Ringer and Earpiece Volume Traveling OUT of Range Tone Dialing SWITCH-OVER Temporarily Mute Ringer RedialChanging the Auto Talk Setting Menu OptionsFlash and Call Waiting Cidcw Entering Your Area CodeDial Choosing the Dialing ModeMemory Dialing Storing Phone Numbers and NamesPress CH/SEL. Store Number is displayed Memory 1 Stored Steps for Entering Names and Special Characters Making Calls with Memory Dialing Memory Dialing from Standby ModeMemory Dialing from Talk Mode If you make a mistake while entering a nameEditing a Stored Name AND/OR Phone Number Chain DialingErasing a Stored Name and Phone Number ONE-TOUCH Speed Dial Testing Stored Emergency NumbersYes Delete Number Storing and Editing the Speed DialMaking Calls with the Speed Dial Deleting the Speed DialCaller ID When the Telephone RingsDeleting Information from the Caller ID List Viewing the Caller ID Message ListYes or No Deleting a Caller ID MessageDeleting all Caller ID Names/ Numbers All? or DeleteDial Edit Long Distance Calls and Area Code Setting/CancellationUsing the Caller ID List Calling a Party from the Caller ID ListChanging the Digital Security Code To attach the beltclip Installing the Optional BeltclipHeadset Installation Additional InformationProblem Solution TroubleshootingUnavailable message is Care Service and RepairPage Page Page RadioShack Corporation