Radio Shack 43-3595 important safety instructions CHARGE/IN USE or

Page 10

Installation

! IMPORTANT !

Be sure the battery pack is

properly connected before

you try to charge it. The

CHARGE/IN USE or

CHARGE indicator illuminates when the handset is on the cradle, even if the battery pack is not connected.

Ô NOTES Ô

If the phone does not work, recharge the battery pack. (The battery power might be too low for the display to operate.)

If the battery pack becomes weak during a call, the handset beeps and Low Battery flashes. When this happens, you cannot make a call on the phone until you recharge the battery pack.

If the battery pack is completely discharged or the base loses power while the handset is away from it, place both handsets on the main base to re-register to the main base.

3.Plug the battery pack’s connector into the socket in the compartment (the connector fits only one way). Place the battery pack in the compartment.

4.Replace the cover.

To charge the battery pack, place each handset on the base or charging cradle. The CHARGE/IN USE and CHARGE indicators on the cradles should light up. !

Recharge the battery pack when Low Battery flashes on the display.Ô

When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear error beeps. If this happens, place both handsets on the main base.

Using a damp cloth, clean the charging contacts on the handsets and cradles about once a month.

About once a month, fully discharge the battery packs by keeping the handsets off the cradles until Low Battery flashes on each handset display. Otherwise, the battery pack loses its ability to fully recharge.

10

Image 10
Contents MHz Cordless Telephone Introduction IntroductionInformation FCC StatementSurge Protection Important Safety Instructions Important Caller ID Information Installation Selecting a LocationInstalling the Charging Cradle On a Wall Plate or WallCONNECTING/CHARGING the Battery Pack Lift the battery pack out of the compartmentCHARGE/IN USE or Before USING, Register Extra Handset to Main Base Unit OWARNING oWhen to RE-REGISTER Handsets Call Transfer Feature To transfer a call to the second handsetOperation Making and Receiving CallsEarpiece Volume Handset Ringer Tone VolumeAdjusting the Handset Ringer and Earpiece Volume Redial Tone Dialing SWITCH-OVERTemporarily Mute Ringer Traveling OUT of RangeChanging the Auto Talk Setting Menu OptionsFlash and Call Waiting Entering Your Area Code CidcwStoring Phone Numbers and Names Choosing the Dialing ModeMemory Dialing DialPress CH/SEL. Store Number is displayed Memory 1 Stored Steps for Entering Names and Special Characters If you make a mistake while entering a name Memory Dialing from Standby ModeMemory Dialing from Talk Mode Making Calls with Memory DialingChain Dialing Editing a Stored Name AND/OR Phone NumberErasing a Stored Name and Phone Number ONE-TOUCH Speed Dial Testing Stored Emergency NumbersYes Deleting the Speed Dial Storing and Editing the Speed DialMaking Calls with the Speed Dial Delete NumberWhen the Telephone Rings Caller IDViewing the Caller ID Message List Deleting Information from the Caller ID ListAll? or Delete Deleting a Caller ID MessageDeleting all Caller ID Names/ Numbers Yes or NoCalling a Party from the Caller ID List Long Distance Calls and Area Code Setting/CancellationUsing the Caller ID List Dial EditChanging the Digital Security Code Additional Information Installing the Optional BeltclipHeadset Installation To attach the beltclipTroubleshooting Problem SolutionUnavailable message is Service and Repair CarePage Page Page RadioShack Corporation