Radio Shack 43-3821 owner manual 100%6+0.%*#4+0#0& 42.#%+06*$#6642#%

Installation		#"+/2146#06"#
		Be sure the battery pack is
		properly connected before
		you try to charge it. The
		CHARGE/IN USE indicator
		lights when the handset is
		on the base even if the
		battery pack is not
		connected properly.
	±"016'"±"
		• If the phone does not
		work, recharge the
		battery pack. (The
		battery power might be
		too low for the display to
		operate.)
		• If the battery pack
		becomes weak during a
		call, the handset beeps
		about every 3 seconds
		and TALK/BATT flashes.
		When this happens, you
		cannot make a call on
		the phone until you
		recharge the battery
		pack.
		• If the battery pack is
		completely discharged
		or the base loses power
		while the handset is
		away from it, place the
		handset on the base to
		reset the security
		access-protection code.
		If it was the handset that
		lost power, recharge the
		battery pack.

6. Lift the base’s antenna to a vertical position.

%100'%6+0)."%*#4)+0)"#0&" 4'2.#%+0)"6*'"$#66'4;"2#%-

The phone comes with a rechargeable Ni-Cd (nickel-cadmium) battery pack installed in the handset, but not connected. Before using your phone, you must connect the battery pack, then charge it for about 24 hours.

1.Press down and slide off the battery pack compartment cover.

2.Lift the battery pack out of the compartment.

3.Plug the battery

pack’s connector into the socket in the compartment. The connector fits only one way.

4.Put the battery pack in the compartment.

5.Replace the cover.

To charge the battery pack, place the handset on the base, face up or down. The base’s CHARGE/IN USE indicator lights. #"

Recharge the battery pack when the handset beeps and TALK/BATT flashes. ±ý

When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear error beeps. If this happens, return the handset to the base for about 5 seconds to reset the security access-protection code.

Using a pencil eraser, clean the charging contacts on the handset and the base about once a month.

10